688813
21
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
EN 21
local air conditioner PAC 2010 E / PAC 2610 E
Condensate discharge (manual draining)
In cooling and dehumidification mode condensate is formed,
which is mostly discharged via the exhaust air.
The remaining condensate is collected in a container within the
housing. The condensate ought to be drained regularly.
If too much condensate accumulates, the device switches off
and indicates this via the H8 indication on the segment
display(13).
1. Carefully transport or wheel the device to a suitable
location for discharging the condensate (e.g. a drain) or
position a suitable collection container underneath the
lower condensate outlet.
2. Remove the rubber stopper from the condensation drain
hose.
3. Detach the condensation drain hose from the retaining clip
and guide the hose to a drain or collection container. To
ensure that the condensate can run off, the hose must not
be kinked, nor should it have to overcome an uphill incline
towards the drain.
4. Let the condensate run, until the condensation drain hose
is completely drained.
5. Reattach the rubber stopper to the condensation drain
hose and put the hose back into the retaining clip. Ensure
the tight fit of the rubber stopper, for otherwise there might
be uncontrolled water leakage.
ð The H8 error code on the segment display(13) will
disappear as soon as the condensate has been drained.
Activities required after maintenance
If you want to continue using the device:
Leave the device to rest for at least 6hours, so the
refrigerant can accumulate within the compressor. Wait
6hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. If so, any warranty claims will be
voided.
Reconnect the device to the mains.
If you do not intend to use the device for a considerable time:
Store the device according to the Storage chapter.
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

trotec-pac2610e

Suche zurücksetzen

  • PAC 2010 E / PAC 2610 E kühlt nicht mehr. Fan funktioniert. Fehler F 0.
    Was kann ich tun? Eingereicht am 8-8-2020 11:13

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Trotec PAC2610E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Trotec PAC2610E

Trotec PAC2610E Bedienungsanleitung - Deutsch - 23 seiten

Trotec PAC2610E Bedienungsanleitung - Holländisch - 23 seiten

Trotec PAC2610E Bedienungsanleitung - Französisch - 23 seiten

Trotec PAC2610E Bedienungsanleitung - Spanisch - 23 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info