Bedienungsanleitung Trotec PGGS 10 - 3.7V (Seite 4 von 14) (Englisch)

753339

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

3 EN

Operating manual – cordless glue gun PGGS 10-3,7V

General Power Tool Safety Warnings – Service

•Have your power tool serviced by a qualified repair

person using only identical replacement parts. This will

ensure that the safety of the power tool is maintained.

General Battery Pack / Charger Safety Warnings

•Use power tools only with specifically designated

battery packs. Use of any other battery packs may create

a risk of injury and fire.

•When battery pack is not in use, keep it away from

other metal objects, like paper clips, coins, keys, nails,

screws or other small metal objects, that can make a

connection from one terminal to another. Shorting the

battery terminals together may cause burns or a fire.

•Recharge only with the charger specified by the

manufacturer. A charger that is suitable for one type of

battery pack may create a risk of fire when used with

another battery pack.

•Do not charge other battery packs. The charger is only

suitable for use with the supplied battery pack and with

the voltages specified in the technical data. Otherwise,

there is a risk of fire and explosion.

•Under abusive conditions, liquid may be ejected from

the battery. Avoid contact. If contact accidentally occurs,

flush with water. If liquid contacts eyes, additionally seek

medical help. Liquid ejected from the battery may cause

irritation or burns.

•In case of damage and improper use of the battery,

vapours may be emitted. Provide for fresh air and seek

medical help in case of complaints. The vapours can

irritate the respiratory system.

•Do not open the battery. There is danger of a short

circuit.

•Do not short-circuit the battery. There is danger of

explosion.

•Batteries must not be exposed to mechanical impacts.

•Protect electrical parts against moisture. To prevent an

electric shock, never immerse them in water or other

liquids during cleaning or operation. Never hold the

charger under running water. Please observe the

instructions for cleaning and maintenance.

•The charger is only suited for indoor use.

•Keep the charger clean. Contamination entails a risk of

electric shock.

•Do not operate the charger on highly combustible

ground (e.g. paper, textiles etc.) or in an inflammable

environment. The heat generated by the charger during

charging entails a risk of fire.

•Only use the charger for charging the battery. The

charger must not be used as power supply for the power

tool.

Device-specific safety warnings for glue guns

•Only place the device on fireproof, non-heat-

conducting and solid surfaces. The heat generated by

the device during operation entails a risk of fire.

•Do not use flammable solvents for cleaning the areas

to be glued. Fire hazard.

•Do not touch the nozzle or the glue stick. The nozzle

and the glue stick can reach temperatures exceeding

170°C.

•Do not allow hot glue to come into contact with people

or animals. In case of skin contact immediately hold the

affected area under a jet of cold water for several minutes.

Do not try to remove the glue from your skin.

•Do not pull the glue stick out of the nozzle. Touching

hot glue can cause severe burns and the power tool can be

damaged.

•Never use the glue gun at ambient temperatures below

5°C or above 50°C.

•Do not use the glue gun in an environment with direct,

cold wind. The device's efficiency decreases and energy

is lost.

•In case of continued use, do not apply excessive

pressure on the trigger. The glue gun can be damaged.

•Tasks which require the housing to be opened must

only be carried out by authorised specialist

companies.

•If the glue escapes towards the rear, stop using the

tool immediately! Have it cleaned by a specialist

company before further use.

Intended use

Only use the device PGGS 10-3,7V for bonding wood,

cardboard, packaging material, leather, ceramic, glass, carpet,

seals, plastic, fabric, cork and metal using hot-melt glue whilst

adhering to the technical data. The workpieces to be bonded

must be clean, dry and free of grease.

We recommend using the power tool with original Trotec

accessories.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Trotec PGGS 10 - 3.7V Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Trotec PGGS 10 - 3.7V

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info