Emergency calls
This phone, like any wireless phone, operates using radio
signals, which cannot guarantee connection in all conditions.
Therefore, you should never rely solely on any wireless phone
for essential communications like medical emergencies. To make or receive calls, the phone must be
switched ON and in a service area with adequate signal strength. To make an emergency call, enter
the local emergency number in standby mode and touch to call.
Care and maintenance
- Your phone is a product of superior design and craftsman
ship and should be treated with care. The suggestions below
will allow you to enjoy this product for many years.
- Keep your phone away from small children and pets. They
may accidentally damage the phone or choke on small
parts.
- Keep the phone dry and avoid liquids that corrode the
phone.
- Do not use the phone with a wet hand, which may cause an
electric shock.
- Do not store the phone in hot areas, which can shorten the
life of electronic devices, damage batteries, or melt
accessories.
- Do not store the phone in cold areas. When the phone
warms up to its normal operating temperature, moisture can
form inside the phone, which may damage the phones
electronic circuit boards.
- Do not expose your phone to hot sunlight which may cause
it to over-heat.
- Do not place your phone near inflammable liquids, gas or
explosive substances.
- Do not drop or knock the phone. Rough handling can break
internal circuit boards.
- When cleaning the phone, use a damp or anti-static cloth.
Do not use a dry or static cloth. Do not use chemicals such
as cleaning solvents to clean the surface. Switch OFF the
phone first before cleaning.
- Do not paint the phone. Paint can prevent proper operation.
- If your phone has a torch, do not use it too close to the eyes.
This may cause damage to eyes.
- If the phone or battery gets wet and the label on the phone is
damaged, phone repairs are no longer guaranteed by the
manufacturer's warranty, even if the warranty for your phone
has not expired.
Declaration of conformity
Hereby, we declare under our sole responsibility that this product and in combination with the
accessories are in compliance with the appropriate standards 3GPP TS 51.010-1, EN 301908-1/-2,
EN 301511, EN 300328, EN 301489-1/-7/-17/-24, EN 60950-1, EN 50360, EN 50361, following the
provisions of, Radio Equipment and
Telecommunication Terminal Equipment directive 99/5/EC with requirements covering EMC directive
04/108/EC, and Low Voltage directive 06/95/EC.
