484752
3
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
3
4
1 . STEREO MAIN OUTPUT
Unbalanced RCA connectors controlled by the master fader.
2 . POWER SWITCH
Press the power switch to turn the unit on. To switch the POWER off press the POWER switch
again.
3 .
FUSES
Under normal operation the fuses should not blow. A blown fuse usually indicates
an overload or fault condition. To change the fuse, remove the power cord, pry off
the fuse block with a small flathead screwdriver and change the blown fuses.
Refer to the specification for fuse current ratings.
4 . AC CORD
Used this cable to connect the AC mains power to the unit
5 . SD PORT
Insert the SD card.
6 . USB PORT
Insert the USB.
7 . DISPLAY
TRACK
CUE
MIN .
SEC.
SIN GLE
CONTIN UE ROBO LOOP
ELAPSED TOT AL REMAIN PROGRAM REPEAT 1 ALL PITCH
,
A B
C
DEF
G
HI
J
KLNM
A. OPERATING MODE
These indicate the operating mode of the SD CARD or USB player
: The SD CARD or USB player is playing the SD CARD or USB.
: The playback is paused.
B. TIME MODE INDICATORS
ELAPSED:
TOTAL REMAINING:
REMAINING:
C. “PROGRAM” INDICATOR
This indicates the player is in programme mode.
D . REPEAT INDICATOR
REPEAT 1:
REPEAT ALL:
E. TIME BAR
INDICATOR
This is a graphical representation of the “Minute, second and frame displays” (C).
F. “PITCH” INDICATOR
This indicates the pitch slider (12) is activated.
G. “LOOP” INDICATOR
This indicates the SD CARD or USB player is currently playing
in a preset loop.
H. PITCH DISPLAY
This indicates the playback speed (pitch), from 16% to +16%.
I. PLAY MODE INDICATORS
SINGLE:
CONTINUE:
ROBO:
J. MINUTE, SECOND AND FRAME DISPLAYS
These
displays shows the current time, the value changes depends on the time mode selected.
K. “CUE” INDICATOR
This indicates a new cue is set.
L. TRACK NUMBER
This displays the position, number of track of the SD CARD or USB, which is playing.
M. FOLDER DISPLAY
N. ID3 COMMUNICATION DISPLAY
The SD CARD or USB player is in single mode.
The SD CARD or USB player is in continue mode.
The SD CARD or USB player is in relay mode.
The SD CARD or USB player is playing the selected track repeatedly.
The SD CARD or USB player is playing the entire SD CARD or USB repeatedly.
Played time of the selected track.
Tot a l remaining play time of the SD CARD or USB.
Remaining play time of the selected track.
8 . BPM EFX
9 .
FX TAP BUTTON
10. CUE TAP BUTTON
11.
first : control the SD card function.
- Press the second: control the USB function.
- Press along time ,after display “P-OFF” and will shut off the power for SD card/USB.
- If you take away the SD card/USB, then pressing the botton, will start up the SD/USB.
15. SKIP>>I BUTTON
In the “TRACK”mode,is next track.
IN BUTTON ( LOOP SYSTEM )
This button sets the beginning of the loop. The Loop indicator on the display flashes.
12. OUT
BUTTON ( LOOP BUTTON )
When you press this button, you set the end point of the seamless loop and you start the loop.
To finish the loop, press again this button.
13. RELOOP BUTTON ( LOOP SYSTEM )
This button is used to
start the last saved loop.
14. SD/USB BUTTON
- Press the
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für US Blaster MAX 7143 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info