529281
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
Vehicle features
Front seat adjustment:
1. Backrest rake
2. Seat height 3
3. Thigh support 3
To adjust front and outboard rear seat
head restraints: Press button on side of
head restraint to release, adjust height
and engage.
Front seat adjustment (continued):
4. Lumbar support 3
5. Seat inclination 3
6. Longitudinal positioning
Important
: Do not sit nearer than
10 inches (25cm) from steering wheel, to
permit safe airbag deployment.
Starting the engine:
Operate clutch and brake pedals.
Automatic transmission 3 in P or N.
Easytronic 3: depress brake pedal,
do not accelerate. Petrol engines:
Turn key to 3. Diesel engines: Turn key
to 2, wait for preheating control
indicator ! to go out, then turn key to 3.
Release key once engine is running.
Adjusting exterior mirrors:
Outer mirror switch pressed: four-way
switch adjusts driver’s and passenger’s
mirror. Inner mirror switch pressed: only
front passenger’s mirror is adjusted.
Electric seat adjustment with
Memory function 3: Select reverse gear
with inner mirror switch pressed; front
passenger’s mirror points to rear tyres
as a parking aid.
Automatic anti-dazzle mirror on driver’s
side 3: Dazzle at night is reduced.
Swinging in exterior mirrors 3:
Push four-way switch to the right:
Exterior mirrors swivel in.
Push four-way switch to the left:
Exterior mirrors swivel out.
Swivelling allowed upto speeds of 4 mph.
If necessary, the exterior mirrors can be
swivelled manually: Press outer edge of
mirror housing gently.
Driving with swivelled-in exterior mirrors
is not permitted.
Fitting seat belt:
Draw seat belt smoothly from inertia
reel, guide over shoulder and engage in
belt buckle.
The belt must not be twisted at any
point. The lap belt must lie snugly
against the body.
The front seat backrests must not be
tilted back too far (recommended
maximum tilting angle approx. 25
o
).
To release belt, press button on buckle.
Turn light switch:
0 =Off
8 = Parking lights
9 =Dipped or main beam
AUTO = Automatic dipped beam
activation 3
Press button:
0 = Courtesy light
> = Front fog lights 3
r = Fog tail light
k = Instrument illumination
? = Headlight range adjustment:
Reduces dazzle for oncoming traffic.
Manual headlight range adjustment:
Without level control system
0 = Front seats occupied only
1 = All seats occupied
2 = All seats and luggage
3 = Driver’s seat only and luggage
With level control system
3
0 = Front seats occupied
1 = All seats occupied
1 = All seats and luggage
2 = Driver’s seat only and luggage
Switching to dipped or main beam:
Main beam = Push stalk forwards.
Dipped beam = Push forwards again.
To operate the headlight flash, pull stalk
towards the steering wheel.
Vehicle features
Door-to-door lighting 3:
Dipped beam and reversing lights
can be set to illuminate for approx.
30 seconds after closing driver's door:
Switch ignition off, remove key, open
driver’s door, pull turn signal stalk
towards steering wheel and close
driver’s door.
If the driver's door is left open, the lights
will extinguish after two minutes.
Cancel by inserting key in starter switch
or by pulling turn signal stalk towards
the steering wheel with the driver’s door
open.
Turn signal lights:
Right = Move stalk up
Left = Move stalk down
After operation, the turn signal stalk
returns to its starting position.
If the stalk is moved past the resistance
point, the turn signal light remains on.
When the steering wheel moves back
towards the straight-ahead position, the
turn signal light is automatically
deactivated.
When lane changing, move stalk to
resistance point and release: turn signal
flashes three times.
Parking lights:
The front parking light and the tail light
on one side of the vehicle can be
activated when parking the vehicle:
Turn light switch to 0 or AUTO 3, switch
ignition off, move turn signal stalk fully
upwards (right parking light) or
downwards (left parking light).
An acoustic signal sounds and the
respective turn signal control indicator
illuminates briefly in instrument cluster.
Remove ignition key before leaving the
vehicle.
Switch off by switching ignition on or by
moving stalk in opposite direction.
Windscreen wiper:
Gently push stalk upwards.
§
§§
§ = Off
$ = Adjustable timed interval wipe
% =Slow
& =Fast
Stalk always moves back to the starting
position. To select the next higher or
lower stage: move stalk slightly.
Push stalk past resistance point and
hold: wiper stages are run through; an
acoustic signal sounds at position §
§§
§.
Adjustable timed interval wipe $:
Adjuster wheel right = Short intervals,
Adjuster wheel left = Long intervals.
Stalk down from position §
§§
§: Single wipe.
Automatic wiping with rain sensor 3:
Gently push stalk upwards.
§
§
§
§ =Off
$ = Automatic wiping with rain sensor
The rain sensor detects the amount of
water on the windscreen and
automatically controls the windscreen
wiper.
Adjust the sensitivity of the system using
the adjuster wheel:
Adjuster wheel right = High sensitivity,
Adjuster wheel left = Low sensitivity.
Keep the sensor area clean by operating
the windscreen wash system regularly.
Windscreen wash system and headlight
wash system 3:
Pull stalk towards steering wheel.
The wiper is switched on for several wipe
operations. A single after-wipe occurs at
low speeds.
The headlight wash system 3 is ready for
operation when the headlights are
switched on. Wash fluid is sprayed onto
the headlights once. Then the headlight
wash system is disabled for 2 minutes.
On vehicles fitted with rain sensor 3,
keep the sensor area clean by operating
the windscreen wash system regularly.
Warning:
In freezing conditions, wiper blades can
freeze to the windscreen. Release wiper
blades from the ice before starting the
vehicle, to prevent wiper motor damage.
Engine oil:
Check every 300 miles and prior to long
journeys.
Important
: It is the owner’s responsibility
to maintain the correct level of an
appropriate quality oil in the engine.
Refuelling:
Use unleaded fuel for petrol engines.
Fuel tank capacity Saloon: 61 litres,
Hatch: 61 litres,
Estate: 60 litres.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Vauxhall Vectra 2007 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Vauxhall Vectra 2007

Vauxhall Vectra 2007 Bedienungsanleitung - Englisch - 324 seiten

Vauxhall Vectra 2007 Bedienungsanleitung - Englisch - 330 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info