2
3
c
g
a
f
d
1
2
3
Putting your cleaner together
Stand the base in the upright
position. Assemble the mid section
onto the base, taking care not to
trap internal mains wire.
Insert the three nuts into the
recesses located on the left and
right sides of the base and into the
recess located in the middle of the
back of the base.
While holding the nuts in place
insert screws through the front of
the mid section and tighten.
Slide the upper handle down onto
the unit. Insert nut into the recess in
the back of the upper handle. While
holding the nut in place insert the
screw through the front of the upper
handle and tighten.
Run the mains wire above the
upper cord hook and secure with
the cord clip.
Phillips screwdriver required
Parts checklist
a Handle
b Clean solution reservoir latch
c Clean solution reservoir
d Dirty water tank latch
e Dirty water tank handle
f Floating brushbar
g Dirty water tank
h Dirty water tank lid
i Power switch
l
q
j Handle screw
k Power cord
l Carrying handle
m Quick cord release
n Handle release pedal
o Cord hook
p Cord clip
q Solution release trigger
j
e
b
o
m
n
p
k
h
i
