Bedienungsanleitung Velleman DVM4000 (Seite 5 von 67) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

622290

Zoom out

Zoom in

Vorherige Seite

1/67

Nächste Seite

WARNING:

For safety reasons, please read the manual.

Remark: this warning is also found on the back of the meter (top part).

WARNING: To avoid electrical shock always disconnect the test leads

prior to opening the housing. To prevent damage or injury, only use

batteries and fuses with the same ratings as specified in this manual.

Remark: refer to the warning on the back of the meter.

Avoid cold, heat and large temperature fluctuations. When the

unit is moved from a cold to a warm location, leave it switched

off until it has reached room temperature. This to avoid

condensation and measuring errors.

Protect this device from shocks and abuse. Avoid brute force

when operating.

Pollution degree 2-device. For indoor use only. Keep this device

away from rain, moisture, splashing and dripping liquids. Not for

industrial use. Refer to §5 Pollution degree.

Keep the device away from children and unauthorised users.

Risk of electric shock during operation. Be very careful when

measuring live circuits. Use extreme caution when measuring voltages

higher than 60Vdc or 30Vac rms.

Do not replace internal parts yourself. Replace damaged or lost

accessories by identical ones with the same specifications. Order spare

accessories e.g. test probes at your dealer.

This is an installation category CAT IV 600V / CAT III 1000V

measuring instrument. Never use this equipment in a higher category

than indicated. Refer to §4 Overvoltage /installation category.

Read this manual thoroughly. Familiarise yourself with the functions of the

device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage

caused by user modifications to the device is not covered by the warranty.

Only use the device for its intended purpose. Using the device in an

unauthorized way will void the warranty. Damage caused by disregard of

certain guidelines in this manual is not covered by the warranty and the

dealer will not accept responsibility for any ensuing defects or problems.

Make sure the meter is in the appropriate measuring range before

connecting it to a test circuit.

Do not measure circuits that may contain voltages > 1000V (DC or rms

AC)

Do not measure current in circuits with voltages > 1000V

Do not conduct resistance, diode- or continuity measurements on live

circuits.

Before each use, make sure the test probes are in good condition. Always

place your fingers behind the protective edges of the test probes while

measuring! Never touch free terminals when the meter is connected to a

circuit.

Switch off the meter and remove test probes prior to replacing the battery

or fuses.

When carrying out measurements on a TV set or switching power circuits,

always be aware that high amplitude voltage pulses at the test points

might damage the meter.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Velleman DVM4000 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info