Bedienungsanleitung Vicks VH188E - Warm Steam (Seite 2 von 2) (Englisch)

650801

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

shuts off, empty the residue in the medicine cup and clean with a soft tissue. Add fresh inhalant after

refilling water container.

• PLUG IN VAPORIZER. IMPORTANT: Vapourizer will NOT START unless vapourizer has been

disconnected for at least one minute. Nightlight will illuminate when electricity is connected. This

will indicate that the heating unit is functioning.

Vapourizer will produce a gentle flow of steam within a few minutes. Do not lift or move the

vapourizer while in use.

• OPERATION: Vapourizer will shut off automatically when the water reaches a minimum level (about

20 mm from bottom of container).

• VENTILATE ROOM REGULARLY: When vapourizer is used in closed or small rooms, check periodically

for proper ventilation, as excessive humidity can cause condensation on walls.

• AFTER EACH USE: Empty any unused water from the container. Rinse container thoroughly, drain

and wipe with a dry, clean cloth. To maintain proper operation of your vapourizer, be sure to follow

CARE AND CLEANING instructions.

Care and Cleaning

IMPORTANT SAFETY CAUTIONS: Always disconnect the plug from the electrical outlet before cleaning.

Remove heating unit, letting all water drain back into the container. Do not attempt to disassemble the

heating unit. Doing so could damage the vapourizer or cause personal injury, and will void the warranty.

Daily Maintenance

Empty any unused water from container. Rinse container thoroughly, drain and wipe with a dry, clean cloth.

Weekly Maintenance

Empty any unused water from container. Rinse

container thoroughly, drain and wipe with a

dry, clean cloth.

Soak heating unit in 8 cm (3 inches) of white

vinegar for 10 minutes (Fig. 4). Use a butter

knife to gently remove any minerals from the

metal heater surface (Fig. 5). Access to the

heater surface can be obtained by lifting the

hinged cover on bottom of unit.

CLEAN THE HEATER SURFACE AFTER EACH

150 HOURS OF OPERATION.

Open hinged cover on bottom of heating unit

for access to the heater surface for cleaning

only. Use a butter knife to gently remove any

minerals from the metal heater surface. More

frequent cleaning may be required in hard-

water areas.

For proper operation, the cover must be shut

and in the correct position.

Instructions

• CORD CAUTION: Unravel cord before use. Failure to do so could cause overheating and possible fire hazard.

• DISCONNECT CORD: Always disconnects cord at wall plug before

removing the heating unit, filling, cleaning, or when not in use.

IMPORTANT: The heating unit will not operate unless the plug has

been disconnected from electrical outlet for about 1-2 minutes

prior to reconnecting.

• REMOVE HEATING UNIT: Lift the rear of heating unit cap and

slowly rotate in a counter-clockwise direction until the slanted

portions of the two locking tabs is cleared. Then lift the heating

unit directly upwards until the locking tabs are clear of the water reservoir. (Fig. 1)

• FILL THE CONTAINER: Fill container with tap water to the MAX water

level marked on the water reservoir.

DO NOT OVERFILL. (Fig. 2)

• REPLACE HEATING UNIT: Align the two locking tabs on the side

of the heating unit with the two slots in the water reservoir. The

heating unit will only engage the water reservoir in the proper

orientation. Seat the heating unit into the locking tabs of the water

reservoir, then rotate the head clockwise to hold unit in place.

• PLACE VAPORIZER IN STABLE POSITION: Vapourizer should

always be placed on a firm, flat surface at least 1.2 meters

(4 feet) from bedside. For safest operation, vapourizer should be placed on floor, where it cannot fall

or be pulled down. Be sure the power cord is out of the way to prevent vapourizer from being upset.

Protect floor, rug or furniture by placing the vapourizer on a non-metallic heat-resistant surface.

CAUTION: Do not direct steam flow directly at recipient, walls or furniture. Recipient will still obtain

desired level of humidity.

KEEP OUT OF THE REACH OF CHILDREN; STEAM CAN CAUSE BURNS. This appliance is not intended

for use by young children or infirm persons without supervision. Young children should be supervised to

ensure that they do not play with the appliance.

• INHALANT STEAM ACTIVATED:

KAZ INHALANT or VICKS VAPOSTEAM can be filled is the medicine cup. Those products are not

delivered with the vapourizer but are available on some websites. You can use steam inhalants or

medicine oils brands available in drugstores and

pharmacies. For best results, fill the medicine

cup on the cap (located in the front of the of the

steam outlet vents) with the steam inhalant or

medicine oil product. DO NOT put this oil or steam

inhalant in the water tank, it must be put in the

medicine cup and not inside the tank. Any brand

or medicine into the water tank will damage the

unit and void the guarantee. (Fig. 3)

These inhalants are designed for use on one

vapourizer cycle (12-14 hours). After vapourizer

IMPORTANT SAFETY INSTRUCTIONS

Read through all the instructions before starting to use the appliance.

Keep this

manual in a safe place for future reference.

These instructions shall also be available on our website.

Please visit www.hot-europe.com.

• This appliance must only be operated as instructed in this user manual.

• This appliance can be used by children aged from 8 years and above and persons

with reduced physical, sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction concerning use of

the appliance in a safe way and understand the hazards involved. Children shall

not play with the appliance. Cleaning and user maintenance shall not be made by

children without supervision.

• This appliance is only designed for indoor use. Do not place it in direct sunlight,

high-temperature areas or near computers or sensitive electronic equipment.

Keep the appliance away from heat sources such as stoves, heaters, etc.

• Place the appliance on a firm, even, non-metallic and waterproof surface. This

humidifier may not work properly on an uneven surface.

• Kaz will not accept responsibility for property damage caused by water spillage.

• Only connect the appliance to a single-phase AC supply to the voltage shown on

the rating plate.

• Do not use an extension cord. Doing so could cause overheating, fire hazard or

electric shock.

• Do not cover the mist outlet or put anything on it while the humidifier is running.

• If surplus humidity forms condensation on walls and windows in closed or small

rooms, turn the power switch to the lower setting and open the door to the room.

• Do not touch the hot steam. Steam can cause burns.

• If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.

• Do not use this appliance if it is damaged or shows any signs of possible damage

or if it is not functioning properly. Disconnect the power plug from the power

socket.

• This humidifier requires regular cleaning. Refer to the cleaning instructions.

• Turn the humidifier OFF if you notice moisture on the inside of your windows.

For proper humidity reading use a hygrometer, which is available in many

hardware and department stores.

• Never use the device with wet hands.

• Never pull the cord, always pull the plug.

• Always ensure that device is on a level surface.

• Always ensure that the cable is fully unravelled and has no knots in it.

Fig.3

Fig.2

Fig.4

Fig.5

Fig.1

Vicks VH188E - Warm Steam Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info