610001
14
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
14
Non Submerged pump: (Page 3, Figure 4 and 5)
- Place the pump outside the pond or reservoir below the water level and water flow
towards the pump itself (the pump is not self-priming).
- Install a hose at least 40 mm in diameter and up to 1.5 m max. (Z) and pressure hose
(P).
- Before putting into operation the suction hose (Z) must be completely filled with
water.
- NOTE: To protect the pump from contamination, put on the suction side a pre-filter.
- NOTE: It will be not possible for fish or other animals to get in the suction line, use a
grating or filter
Overload protection:
The built-in safety stops the pump in case of overheating. Unplug the appliance and let it
cool. The pump must not be turned back on after uncontrolled cooling.
First check the following points:
- Is there enough water available?
- Is the filter clogged?
- Is there dirt in the pump?
- Are hoses or nozzles clogged?
- Is the pump cool down?
Are the issues solved, you can run the pump.
Maintenance
To ensure a long life and problem-free operation, we recommend that you maintain and
clean your pump regularly.
- Follow the safety instructions.
- Pump maintenance depends strongly on the level of water contamination. Regularly
check the filter cap for clogging to prevent the pump from sucking water.
- Turn the pump off before taking it out of the water for maintenance.
- Clean the filter cap and remove all debris from its slots.
- Remove the filter cap from the pump to open the motor housing, by turning the
screws out.
-
Get the impellor out from the motor. Pay attention to the o-ring which sits on the
motor housing.
- Clean all parts with clean water.
- Replace the defective parts. (page 11)
- Place the impellor back into the motor and close the motor housing.
Important! When there is a lot of calcium in the water, it is important to clean the split tube
and impellor in the motor regularly.
In the winter
- Protect the pump from frost.
- Take the pump out of the water before the frost season sets in.
- Clean the pump as described earlier, before putting it in storage.
- Store it in a dry and frost-free area.
English
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Vivaria VarioTec N-15000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info