Bedienungsanleitung Vornado 143 (Seite 10 von 14) (Englisch)

774064

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

10 English

The remote control comes with a 3 Volt lithium

coin cell battery (CR2032). To install, remove

the battery cover on the bottom of the remote

control. If necessary, clean the battery contacts

and also those of the device prior to battery

installation. Remove any plastic protection from

the battery and place it in the remote with the +

side facing out. Ensure the batteries are installed

correctly with regard to polarity. Then reposition

the cover onto the bottom of the remote. If

your remote does not work, please try replacing

with a new 3 Volt CR2032 battery, taking care to always use the correct size and grade of

battery for this product.

HOW TO USE

FAN SPEED (A) The fan speed can be adjusted by pressing the SPEED button. Press

the button to switch between the unit’s speed settings. Lights on the unit’s control panel

indicate the selected speed setting.

POWER (B) The unit powers ON and OFF by pressing the POWER button. Lights on the

unit’s control panel indicate the power is ON.

TIMER (C) The unit has an automatic timer to turn the unit OFF at intervals of 1, 2, 4 or 8

hours. To set the timer, turn the unit on and select desired speed. Press the timer button

until the desired run time light is illuminated. The unit will continue to run until that

amount of time has expired.

REMOTE CONTROL This unit comes with a remote control. The remote control functions

are the same as the control panel on the unit. The remote requires a line-of-sight path

to allow for the signal to be received by the unit. Position the unit so the receiver lens

(located above the Vornado logo) is visible from the remote control. The remote control

can be stored with the Tower Circulator using the magnetic bowl-shaped cradle located

on the top of the product.

REMOTE BATTERY

1. For battery replacement, the remote requires one coin style 3V CR2032 battery. Always

use the correct size and grade of battery for this product.

2. To replace battery, open battery door on the back side of the remote control (you will

need to loosen the small screw on door using a #1 Phillips screwdriver). If necessary,

clean the battery contacts and also those of the device prior to battery installation.

Remove any plastic protection from the battery and place it in the remote with the +

side facing out. Ensure the battery is installed correctly with regard to polarity. Replace

the battery door and screw.

Note: Remove battery from the remote control when not in use for an extended period

of time and always remove dead battery immediately and replace with fresh. Do not store

dead battery in remote.

WARNING: This product contains a button battery. If swallowed, it could cause

severe injury or death in just 2 hours. Seek medical attention immediately.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Vornado 143 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info