Bedienungsanleitung Wagner ProSpray 3.21 (Seite 4 von 32) (Englisch)

649019

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

4 ProSpray 3.21

Safety Regulations

1. Safety regulations for Airless

spraying

This manual contains information that must be read and understood

before using the equipment. When you come to an area that has one of

the following symbols, pay particular attention and make certain to heed

the safeguard.

This symbol indicates a potential hazard that may cause

serious injury or loss of life. Important safety information

will follow.

Attention

This symbol indicates a potential hazard to you or to the

equipment. Important information that tells how to

prevent damage to the equipment or how to avoid

causes of minor injuries will follow.

A hazard symbol such as this one refers to a specific,

task-related risk. Be sure to heed the safeguard.

Notes give important information which should be given

special attention.

HAZARD: INJECTION INJURY

A high pressure stream produced by this equipment

can pierce the skin and underlying tissues, leading to

serious injury and possible amputation.

DO NOT TREAT AN INJECTION INJURY AS A

SIMPLE CUT! Injection can lead to amputation. See a

physician immediately.

The maximum operating range of the unit is 221 bar

(22.1 MPa, 3200 PSI) uid pressure.

PREVENTION:

• NEVERaimthegunatanypartofthebody.

• NEVERallowanypartofthebodytotouchtheuid

stream.DONOTallowbodytotouchaleakintheuid

hose.

• NEVERputyourhandinfrontofthegun.Gloveswill

not provide protection against an injection injury.

• ALWAYSlocktheguntrigger,shuttheuidpumpoff

and release all pressure before servicing, cleaning

the tip guard, changing tips, or leaving unattended.

Pressure will not be released by turning off the engine.

ThePRIME/SPRAYvalveorpressurebleedvalve

must be turned to their appropriate positions to relieve

system pressure.

• ALWAYSkeeptipguardinplacewhilespraying.The

tip guard provides some protection but is mainly a

warning device.

• NEVERuseaspraygunwithoutaworkingtriggerlock

and trigger guard in place.

• ALWAYSremovethespraytipbeforeushingor

cleaning the system.

• Thepainthosecandevelopleaksfromwear,kinking

and abuse. A leak can inject material into the skin.

Inspect the hose before each use.

• Allaccessoriesmustberatedatorabovethe

maximum operating pressure range of the sprayer.

This includes spray tips, guns, extensions, and hose.

NOTE TO PHYSICIAN:

Injection into the skin is a traumatic injury. It is

important to treat the injury as soon as possible. DO

NOT delay treatment to research toxicity. Toxicity is a

concern with some coatings injected directly into the

blood stream. Consultation with a plastic surgeon or

reconstructive hand surgeon may be advisable.

HAZARD: EXPLOSION OR FIRE

Solvent and paint fumes can explode or ignite. Severe

injury and/or property damage can occur.

PREVENTION:

• Provideextensiveexhaustandfreshairintroduction

to keep the air within the spray area free from

accumulationofammablevapors.

• Avoidallignitionsourcessuchasstaticelectricity

sparks,electricalappliances,ames,pilotlights,hot

objects, and sparks from connecting and disconnecting

power cords or working light switches.

• Plasticcancausestaticsparks.Neverhangplastic

to enclose spray area. Do not use plastic drop cloths

whensprayingammablematerials.

• Alwaysushunitintoseparatemetalcontainer,atlow

pump pressure, with spray tip removed. Hold gun

rmlyagainstsideofcontainertogroundcontainerand

prevent static sparks.

• Donotsmokeinsprayarea.

• Fireextinguishermustbepresentandingoodworking

order.

• Placesprayeratleast6.1m(20feet)fromthespray

objectinawellventilatedarea(addmorehoseif

necessary).Flammablevaporsareoftenheavierthan

air. Floor area must be extremely well ventilated. The

pump contains arcing parts that emit sparks and can

ignite vapors.

• Theequipmentandobjectsinandaroundthespray

area must be properly grounded to prevent static

sparks.

• Useonlyconductiveorearthedhighpressureuid

hose. Gun must be earthed through hose connections.

• Powercordmustbeconnectedtoagroundedcircuit

(electricunitsonly).

• Theunitmustbeconnectedtoanearthedobject.Use

the green earthing wire to connect the unit to a water

pipe, steel beam, or other electrically earthed surface.

• Followmaterialandsolventmanufacturer’swarnings

andinstructions.Befamiliarwiththecoatingmaterial’s

MSDS sheet and technical information to ensure safe

use.

• Donotusematerialswithaashpointbelow21°C

(70°F).Flashpointisthetemperatureatwhichauid

can produce enough vapors to ignite.

• Uselowestpossiblepressuretoushequipment.

0 bar

Wagner ProSpray 3.21 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info