Bedienungsanleitung Whirlpool ADG 555 (Seite 24 von 27) (Englisch)

539852

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

In order t o avoid th at there is more water staying in the i nlet hose,

please close the hyd rant after using.(For the models : no s afet y inlet hose.)

Positioning the Appliance

How to Drain Excess Water From Hoses

If the si nk is 1000 hi gher fr om t he floor, the exces s wa ter i n h oses cannot b e dr ai ned di re ctl y

into the sink. It will be necessary to d rain excess water from hoses into a bowl or suitable

conta iner th at is he ld outside and lower t han the sink.

Water Outlet

Connect the water drain hose. Thedrain hose must be correctly fitted to avoid water leaks.

En sure tha t th e wat er i nl et hose i sno t ki nked or s quashed .

The following things should be checked before starting the dishwasher.

Syphon Connection

Th e was te conn ectio nmust be a t a h eight of betw een 50 c m ( minimum ) a nd 10 0cm (m aximum )

fromthe bottom of thedish. The water drain hose should be fixed by a hose clip.

Start of Dishwasher

The content of this manual is very helpful to the users.

After installation, please make sure to keep this manual.

Extension Hose

If you need a dr ain hose exte nsi on, make sure to use a simila r dra in ho se.

It must be n o lon ge r than 4 metre s; o therwise the cleanin g e ff ect o f t he dishwa she r cou ld b e re duce d.

1 The dishwasher is level and fixed properly

2 The inlet valve is open

3 There is a leakage at the connections of the conducts

4 The wires are tightly connected

5 The power is switched on

6 The inlet and drain hoses are knotted

7 All packing materials and printings should be taken out from the dishwasher

Connect the cold water supply hose to a t hreaded 3/4(inch) connector a nd make s ure

tha t it is fas tened tigh tly i n place .

If the water pipes are new or have not been used for an extended period of time, letthe

water run to make sure that the water is clear. This p recaution is needed to avoid the

risk of the water inlet to be blocked and damage the appliance.

Thewater supply to the appliance can also be connected to the household hot water

line(such as, central system, heating system),as long as it does not exceed a

temperature of 60 C. In this case, the w ash cycletimewill be shortened by about 15

minutes and the washefficiency slightly reduced.

The connection must be made to the hot water line following the same procedures as

described in the section for the connection to the cold wat er line.

Positi on the app lianc e i n the desired location. The bac k sh ould rest ag ain st the wall behind i t, an dthe sid es,

along the adj acent c abin ets or wall s. The dis hwa sher is equipp ed w ith wate r supply and drai n ho ses that can

be positioned ei ther to the right or the left sides to facilitate pro per installation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ADG 555 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ADG 555

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info