RINSE AID INDICATOR
When lit (at the end of the cycle), the
rinse aid dispenser needs to be refilled.
5019 300 01393
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it
indicates the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” next page.
TABLET SETTING
This setting allows to optimize
the cycle performances
according the type of detergent
used.
Push the Tablet button for
3 seconds (until the indicator
lights up) if you are using the
combined detergents in tablet
(rinse aid, salt and deteregent
in 1 dose).
If you are using powder
detergent or liquid detergent,
the Tablet indicator on the
control panel has to be off.
START/RESUME BUTTON
Push this button to start the
selected program: the indicator
lights up and goes off at the end of
the program.
When the door is opened during
a washing cycle, the cycle is
temporarily paused: the Start
indicator blinks.
To resume the cycle push Start
button and close the door
within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the
control panel.
If pressed when a program is
running it cancels the program
ongoing draining water for
1 minute (0:01 is shown into
the display).
If pressed when the
dishwasher is switched off,
it drains any possible liquids
from dishwasher (1 minute
process).
HALF LOAD BUTTON
Half load cycle can be used for
the upper or lower rack.
Select the required program
then press the “Half Load”
button - the light comes on.
Turns off at the end of the
program.
The “Half Load” option can be
used with the programs
indicated in the table of
programs.
DELAYED START BUTTON
Push the button (repeatedly) to
delay the start of the program -
delay indicator turns on.
Adjustable from 1 to 24 hours.
With each press of the button,
the delay increases by one hour
and after “h 24” returns to
“h 00”.
When this option is selected
the delay indicator turns on.
Then press the START button.
The dishwasher will start after
the set time.
