Bedienungsanleitung Whirlpool adg 9929 2 (Seite 4 von 8) (Englisch)

128181

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

3. HOW TO USE THE APPLIANCE

c. How to adjust the rinse aid dosage regulator

The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less

rinse aid is dispensed (factory setting: position 4).

Press the button

to open the cover.

Using a coin or similar object, turn the arrow to the desired setting.

After adjusting the rinse aid setting, shut the cover again.

If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is

not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). Plastic dishes

have more difficulty drying and a higher rinse aid setting will not improve the situation.

HOW TO CHECK/FILL/ADJUST SALT

Only use

regeneration salt specifically for dishwashers.

a. How to check the salt level

Depending on the model, check the visual indicator . The window on the salt reservoir cap is clear when salt

needs to be added and orange when the salt present is sufficient. In the case of appliances with an electric indicator on

the control panel, the salt indicator lamp lights up red when salt needs to be added.

b. How to fill the salt container

- Remove the lower rack.

- Turn the salt container cap anti-clockwise to open it.

- When using the dishwasher for the first time, fill the salt container to the rim with water.

- Using the funnel provided, fill with regeneration salt to the rim (the first time,

min. 1.5 kg/max. 2 kg).

- Stir with the handle of a wooden spoon to help dissolve the salt.

- Close the cap of the salt container by turning it clockwise.

- Reinsert the lower rack.

Once regeneration salt is added,

immediately

start a wash programme (the “Pre-wash”

programme alone is

not

sufficient). Residual saline solution or grains of salt can lead to deep-

down corrosion, irreparably damaging the stainless steel components. The guarantee is not

applicable if faults are caused by such circumstances.

The salt level indicator lamp may remain lit for the duration of several wash cycles.

If the water hardness level falls within category 1 (soft),

salt is required.

c. How to set the water hardness level

- Switch on the appliance.

- Select the 2nd programme “P2” - consult the table 1.1 in chapter 1.

- Press the START button for at least 5 seconds until the START indicator lamp flashes.

- The set water hardness level is shown on the display (if present) or the START button flashes.

- With each successive touch of the START button the setting increases and when it reaches 7 it returns to 1 again.

- The appliance must be switched off to memorise the new setting.

Water hardness level is factory set at 3 for medium-hard water (display 4 or 4 flashes of the

START button).

Water hardness level 4 with combined action detergent

Even if you use a combined action detergent which includes salt, you must still add regeneration

salt since such detergents are not effective enough at softening hard water.

If the appliance is equipped with the function “Select detergent” (see chapter “1. Overview”),

set the detergent dispenser system to the “no salt” setting so that the salt indicator lamp remains

activated (“Detergent with rinse aid”).

Water hardness German degrees

°dH

French degrees

°fH

English degrees

°eH

Flashing frequency

or display setting

1 soft 0 - 5 0 - 9 0 - 6.3 1 / 1x

1 - 2 medium 6 - 10 10 - 18 7 - 12.6 2 / 2x

2 medium 11 - 15 19 - 27 13.3 - 18.9 3 / 3x

3 medium-hard 16 - 21 28 - 37 19.6 - 25.9 4 / 4x

4 hard 22 - 28 38 - 50 26.6 - 35 5 / 5x

4 very hard 29 - 35 51 - 63 35.7 - 44.1 6 / 6x

4 extremely hard 36 - 60 64 - 107 44.8 - 74.9 7 / 7x

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool adg 9929 2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool adg 9929 2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info