BEFORE USING THE COOKING HOB
Before use, remove:
- adhesives stuck on the hob;
- cardboard guards and protective plastic film;
- check whether the hob has been damaged during
transport. If in doubt, contact the After Sales Service.
Care and maintenance
• Clean the hob, when it is cool, after each use. This will
prevent the build-up of dirt and make cleaning easier
• Use a clean cloth, absorbent kitche
up liquid or a specific glass ceramic cleaner
• Remove baked-on dirt with the special scraper tool
(if provided) and specific cleanin
• Any food spills should becleaned off before they dry
• Do not use abrasive products, chlorine-based cleaners,
oven-cleaner spray or pan scourers.
• The hob should be treated period
products available from the shops, following the
manufacturer
T
The hob does not
- Make sure that the power supp
- T
problem has been solved.
- Make sure that the knob is not turned to “0”.
T“O ” for a few minutes
and then turn it back to “O.
The hob will not sw
- disconnect the hob immediately from the power
supply
AFTER SALES SERVICE
Before you call the After Sales Service
• Make sure that you cannot solve the problem yourself
following the points descri
“T
If after the above checks the fault still occur
with the nearest After Sales S
Please give:
• a short description of the fault;
• the exact type and model of hob;
• service number (i.e., the number that follows the word
SERVICE on the rating plate under the hob itself);
•y
• your telephone number
If any repairs are required, please contact an Afte
Sales Service (to guarantee that original spare parts will be
used and repairs carried out correctly).
Failure to comply with these instructions may compr
the safety and quality of the product.
INSTALLATION
Rec
Important: Disconnect
carrying out any installation work or servicing.
• All electrical connections must be made before
connecting the appliance to the power supply
• Installation mu
in accordance with the manufacturer’s instructions and
in compliance with local regulations.
• Unpack the hob and make sure that the appliance has
not been damaged during transport. If you are not sure
contact the dealer or the nearest se
Preparing the hous
• Cut the w
Carefully remove any shavings or sawdus
prevent the appliance from running properly
Attention: to install the hob on other surfaces than wood
(marble, plastic, ceramic, marble, stone, etc.) remember to
ask After Sales Service for the fixing plates (fig. 2)
Code 4819 404 7869
• The hob must be fitted in a worktop with a minimum
thickness of 20 mm and a maximum of 50 mm.
• Insert a separator panel at a minimum distance
20 mm from the bottom o
accessed by the user
• If there is an oven under the hob, make sure that it is
manufactured by us and equipped with a cooling
system.
• There must be nothing between the hob and the oven
(e.g. cables, insulating material
• An adjacent column unit must be installed at least
100 mm from the edge of the hob.
• Cut an opening in the
• We internal edges of the
worktop with wood glue or silicone.
• If not already in place, apply the supplied
hob, after cleaning the ad
Glass-ceramic hob
Important: remove any protective film b
hob.
Make sure that that the opening
cut according to the dimensions given in the drawing, paying
attention to the tolerance range.
The hob should not be forced into the worktop. Forcing the
glass-ceramic top may cause it to crack (even at a later date)!
• If the worktop is made of wood , use the spring clips and
screws provided.
1. Secure the spring clips (A) (fig. 1) with the screws
provided (B) (fig. 1) as shown, paying attention to the
specified distan
2. Fit the hob into the worktop.
• If the worktop is made of marble, plastic, ceramic,
stone, etc., the hob must be secure
brackets (C) (fig. 2).
1. Fit the hob into the worktop (fig. 1).
2. Place the 4 brackets (C) in position in accordance with
thickness of the worktop as shown in fig. 2.
3. Fasten the 4 screws (D) in the positions (E) (fig. 2).
Connecting the hob to the power supply
The installer is responsible for connecting appliances
to the mains and for observing the safe
Note: the yellow/green earth wire must be connected to
screw with the symbol .
• Strip approx. 70 mm of the cable sheath from the
power supply cable (G).
• Strip approx. 10 mm of sheath from the conductors.
Insert the cable (G) through the opening in the (F).
• Insert the cable into the cable clamp and connect the
conductors to the terminal block as indicated in the
diagram printed on the lid.
• Secure the po
(G)
by mean
• Refit the protection (F).
• After the electrical connection, fit the hob from the top
and hook it to the fixing springs, according to the
illustration.
Declaration of conformity
• This cooktop has been designed, constructe
marketed in compliance with:
- safety objectives of the “Low V
2006/95/CE (which replaces 73/23/CEE a
subsequent amendments).
- the protection requirements of Directive “EMC
2004/108/CE.
• This cooktop is suitable for contact
complies with EEC (CE
PROTECTING THE ENVIRONMENT
Disposal of
• The packing material can all be fully recycled, as
confirmed by the recycl .
• The various parts of the packing must not be sent for
waste, but recycled in conformity with the regulations
imposed by local
Disposal of used household
• This appliance is
directive 2002/96/EC on W
Equipment (WEEE). By ensuring this product is
disposed of correctlyll help prevent potential
negative consequences for the environment an
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this appliance
may not be treated as household waste. Instead it shall
be handed over to the applicable collection point for the
recycling of electrical and electronic equipment.
Disposal must be cart in accordance with local
environmental regulations for waste disposal. For more
detailed information about treatment, r
recycling of this product, please contact your local city
office, your household waste disposal service or the
shop where you purchased the product.
Energy saving
• Use pots and pans whose bottom diameter is equal to
that of the cooker plates, or slightly larger
• Only use flat-bottomed pots
• If possible, ke
• Cook vegetables, potatoes, etc. with little water in
order to cut down cooking time.
• A pressure cooker allows you to save even more energy
and time.
