515823
25
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
128
CHECKS AND TEST RUN AFTER
INSTALLATION
Check Items After Installation
Test Run
1. Preparation of Test Run
Do not switch on the power before all installation work is completed.
Confirm that the control line is correctly installed and all electrical lines are securely connected.
Open the shutoff valves of the large and small pipes.
Clear the unit of any foreign bodies, especially metal scraps, line ends and tools.
2. Test Run (Fig. 2 page 128)
Plug in, press the “ON/OFF” key on the remote control, and the air-conditioning unit should start.
Press the Mode key, select the operating modes such as cooling and fan, and check for normal operation.
ELECTRIC HEATING BELT
Check items Problems caused to improper installation
Is the installation secure? The unit may fall, vibrate or make noise
Has gas leakage been checked? May cause unsatisfactory cooling (heating) effect
Is the thermal insulation of the unit sufficient? May cause unsatisfactory cooling (heating) effect
Is drainage smooth? May cause condensation and dripping
Is the main supply voltage the same as the
rated voltage specified on the nameplate?
The unit may break down or components may burn out
Are the lines and pipelines correctly installed? The unit may break down or components may burn out
Has the unit been safely grounded? Risk of electrical leakage
Are the models of lines in conformity with
requirements?
The unit may break down or components may burn out
Are there any obstacles near the air inlet and
outlet of the indoor and outdoor units?
May cause unsatisfactory cooling (heating) effect
Have the length of refrigerating pipe and
refrigerant charge amount been recorded?
It is difficult to know how much refrigerant to use
ELECTRIC HEATING BELT FOR INVERTER MODEL
AMC 996, AMC 998 ONLY
In case of malfunction of the outdoor temperature sensor, both
electric belts stop working. Under normal conditions,
operations is as follows:
1.
When the outdoor temperature is -5° or less and the
compressor does not start, the electric heating belt on the
compressor start; if the compressor is running or does not
start but the outdoor temperature is > -2°C, the electric
heating belt does not start. If the compressor does not start
and the outdoor temperature is between -5°C and -2°C the
electric heating belt on the compressor maintains its current
status.
2.
When the outdoor temperature is less or equal to 3°C the
electric condenser heating belt will work. If the outdoor
temperature is greater than 6°C it will not work. Between
3° and 6°C it maintains its current status.
Electric heating belt
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Whirlpool AMC 998 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Whirlpool AMC 998

Whirlpool AMC 998 Bedienungsanleitung - Deutsch - 25 seiten

Whirlpool AMC 998 Bedienungsanleitung - Holländisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info