515834
16
Zoom out
Zoom in
Vorherige Seite
1/18
Nächste Seite
37
4. Connecting the Cable
Indoor Unit
Connect the power cord to the indoor unit by connecting the wires
to the terminals on the control board individually in accordance with
the outdoor unit connection.
NOTE:
It is necessary to remove the cabinet to perform connections with
the indoor unit terminal.
Outdoor Unit
-
Remove the access door from the unit by loosening the screw.
Connect the wires to the terminals on the control board individually
as follows.
-
Secure the power connecting cord on the control board with a cable
clamp.
-
Refit the access door in the original position and tighten the screw.
-
Use a recognized circuit breaker for 24 K model between the power
source and the unit. A disconnecting device to adequately disconnect
all supply lines must be fitted.
CAUTION:
1. Use an individual power circuit specifically for the air
conditioner. As for the wiring method, refer to the circuit
diagram on the inside of the access door.
2. Check that the cable thickness conforms to the power
source specification.
(See the cable specification table below)
3. Check the wires and make sure that they are all tightly
fastened after cable connection.
4. Be sure to install an earth leakage circuit breaker in a wet
or moist area.
Cable Specifications
Attention:
Accessibility to the plug must be guaranteed even after the installation of the appliance to disconnect it
in case of need. If not possible, connect appliance to a double-pole switching device with contact
separation of at least 3 mm
2
placed in an accessible position even after installation.
Front panel
Terminal (inside)
Cabinet
Chassis
Indoor Unit
Outdoor Unit
Access
door
Terminal
(inside)
Capacity
(Btu/h)
Power cord Power connecting cord
Power connecting cord
(for heat pump)
Main
power
supply
Type
Normal cross
- section area
Type
Normal cross
- section area
Type
Normal cross
- section area
7 K-9 K-12 K H05VV-F
1.0-1.5 mm
2
X 3
H07RN-F
1.5 mm
2
X 3
H05RN-F
0.75 mm
2
X 2
To indoor
18 K H05VV-F
1.5-2.0 mm
2
X 3
H07RN-F
1.5 mm
2
X 3
H05RN-F
0.75 mm
2
X 2
To indoor
24 K H07RN-F
2.5 mm
2
X 3
H07RN-F
1.5 mm
2
X 3 (heat pump)
H05RN-F
0.75 mm
2
X 3
To outdoor
2.5 mm
2
X 4 (cool only)
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Whirlpool AMD 009 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Whirlpool AMD 009

Whirlpool AMD 009 Bedienungsanleitung - Deutsch - 18 seiten

Whirlpool AMD 009 Bedienungsanleitung - Holländisch - 18 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info