Bedienungsanleitung Whirlpool ARC 6708 IX (Seite 4 von 4) (Englisch)

71385

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

FAN COMPONENTS

Fan base

Fan cover

Light bulbs

Fan

Antibacterial filter grille

Notches for removing the cover

How to replace the light bulb

Before replacing the light bulb, make sure to disconnect the

appliance from the mains power supply.

Immediately afterwards:

•

Remove the fan cover by grasping the notches (6) and

pulling outwards.

•

Remove the bulb by pulling it out (the bulb is of a special

push-in type - do not rotate the bulb).

•

Check the bulb and, if necessary, replace it with a new one:

Push the bulb into the fitting till it stops.

•

Mount the cover so that it clicks.

Warning:

•

Do not leave the bulb uncovered

•

The bulb must not exceed 15W.

•

It is available at our After-Sales Service outlets.

Malfunction and After-sales Service symbol

(Call After-sales Service)

Listeria indicator - the coldest zone inside the

refrigerator (depending on model)

Coldest temperature inside the refrigerator

The symbol indicates the coldest zone in the

refrigerator compartment. For optimum

temperature adjustment, the refrigerator is provided

with a temperature indicator to allow you control

the average temperature.

Checking the temperature

After the appliance has been switched on for at least

24 hours, can be checked if the temperature in the

refrigerator is correct and, if necessary, adjust the

setting as indicated in the user instructions (see

“Adjusting the temperature”).

The internal temperature of the refrigerator

depends on various factors such as the ambient

temperature of the room, the amount of food stored

and how often the door is opened. These factors

should be taken into account when setting the

appliance.

If the symbol is switched OFF, it means that the

temp. inside the refrigerator is too warm; in this case

adjust the temperature setting and wait for at least

12 hours before checking again if the temp, is

correct.

IMPORTANT

: after opening the door or loading the

refrigerator, it is normal if the symbol is switched

OFF for some time, especially if room temperature

is very warm.

Cleaning

Press the Stand-by button, which allows you to

switch off the refrigerator compartment alone,

keeping the freezer on.The refrigerator

compartment can now be emptied and cleaned.

Changing the position of shelves:

Your refrigerator allows you to change the position

of shelves according to your needs.

•

To remove the shelf, pull it forward to the stop.

•

Keep the lock pressed down as shown in the

picture detail, and pull the shelf frontward until it is

released. The locks can be pressed separately.

•

Pull the pins outward to remove the rails.

•

Remove the rails as in the picture and place them

where you wish.

•

To place the rails observe the inscription “ ”

written on the rail.

•

After that, place the shelf on them.

5019 637 01013

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ARC 6708 IX Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ARC 6708 IX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info