Bedienungsanleitung Whirlpool AWE 9633 (Seite 2 von 2) (Englisch)

576308

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

PREPARING THE WASH CYCLE

Load the machine, close the drum doors and check

that they are properly locked.

2. Add detergent and eventual additives as described on

the front page and in your Instructions for use.

3. Close the lid.

4. Turn the programme selector to the desired

programme and temperature. The time display

shows the duration of the chosen programme (in

hours and minutes), and the lamp next to the

“Start(Pause)” button flashes. The indication

lamp of the predefined spin speed lights up. If you

do not start the programme soon after having

made your choice, the washing machine will switch

off automatically after about a quarter of an hour.

Switch on the washing machine again by turning the

programme selector back to „Off/O“ and then to the

desired programme.

SELECT ANY DESIRED OPTION

Push the button(s) of any option(s) desired -

the respective indication lights up. When the

combination of programme and additional

option(s) is not possible, the indication lights

switch off automatically. Unsuitable combinations

of options are deselected automatically.

“Cold wash” button

• Water is heated only up to 20°C.

• Suitable for delicate laundry items with wash

temperature recommendation of max. 30°C on the

care label.

• Selectable only on the lowest temperature step

of each programme.

“Prewash” button

• Only for heavily soiled loads (for example

sand, granular dirt). Increases the cycle time by

approximately 15 min.

• Do not use liquid detergent for the main wash when

activating the Prewash option.

“Rapid” button

• Enables quicker washing by shortening the

programme duration.

• Recommendable for small loads or only lightly soiled

laundry.

“Intensive rinse” button

• More water is added and rinse cycle is prolonged.

• This option is particularly suitable for areas with very

soft water, washing baby linen and helping people

with allergies.

“Rinse hold” button

• The laundry remains in the last rinse water without

progressing to the final spin cycle to avoid creasing

and prevent colours from changing.

• It is particularly useful if you want to postpone

spinning to a later time, or if you want to drain only.

• If you select “Rinse hold”, do not leave items to soak

for too long.

Note: The programme stops to “Rinse hold” at

the time the “Rinse hold” light in the programme

sequence indicator is on. The indication lamp next to

the “Start(Pause)” button blinks.

Terminate the “Rinse hold” option:

• Press the “Start(Pause)” button; the programme

will terminate automatically with the final spin cycle

for the present wash programme.

• If you do not wish to spin the clothes, turn and hold

the “Reset” button for a few seconds to start the

Drain programme.

“Spin” button

• Every programme has a predefined spin speed.

• Press the button to set another spin speed.

• If spin speed “0” is selected, the final spinning is

cancelled but intermediate spin peaks remain during

the rinse. The water is drained out only.

START DELAY

The “Start delay” button allows the user to run the

machine at his c onvenience, for example at night when

electricity is cheaper.

• Do not use liquid detergent when activating the

“Start delay”.

• Select programme, spin speed and options.

• Press the “Start delay” button several times to select

a delay time by 1 to 23 hours.

• Start the programme (see “Progremme Start”). The

indication lamp over the “Start delay” button lights

up and goes off when the programme starts.

• Once having pressed the “Start(Pause)” button,

the countdown of the time delay begins. The time

delay indication on the display disappears when the

programme starts and is replaced by the remaining time.

• After the “Start(Pause)” button has been pressed,

the number of hours preselected can be reduced by

pressing again the “Start delay” button.

To cancel the “Start delay”

..before you press the “Start(Pause)” button:

• Turn the programme selector to another position or

press the “Reset” button.

..after having pressed the “Start(Pause)” button:

• Press the “Reset” button for at least 3 second. The

start delay indicator light goes off.

PROGRAMME START

Open the tap and press the “Start(Pause)” button.

The indication lamp next to the “Start(Pause)” button

lights up. The programme sequence indicator shows the

current programme phase, running from left to right

through Wash, Rinse, Spin/Drain. When the programme

phrase is finised, the corresponding indication goes out.

• Note: If there is a power interruption or if the

appliance is disconnected during the cycle, the

programme will run again from the point where it

was interrupted.

“LID OPEN” INDICATION

Before starting and after end of a programme, the lamp

lights to show the the lid can be opened. As long as a

wash programme is running, the lid remains locked and

must on no account be forced open. In case you have

an urgent need to open it during a running programme,

refer to “Cancel a running programme before the end”

FAILURE INDICATIONS

In case of any failures or irregularities, consult the

“Troubleshooting Guide” in your Instructions for Use.

Water tap closed -

no or not sufficient inlet water.

Service -

failure or malfunction of an electrical component.

Clean pump -

waste water is not pumped out.

Spin speed on display blinks:

unbalance during spinning

•

PROGRAMME END

The “Lid open” indicator lights up, ( and the display

shows “End”.) After about a quarter of an hour, the

washing machine will switch off completely to save

energy.

1. Turn the programme selector to the “Off/O”

position.

2. Close the water tap.

3. Open lid and drum and unload the machine.

4. Leave the lid open for some time to allow the interior

of the machine to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

Press the “Start(Pause)” button to pause the

programme. The light blinks.

2. Select the new programme, temperature, any

options and another spin speed if you want.

3. Press the “Start(Pause)” button again. The new

programme continues at the same position where the

previous programme was interrupted. Do not add

detergent for this programme.

CANCEL A RUNNING PROGRAMME BEFORE

THE END

The “Reset” button cancels a programme before the

end. Press the “Reset” button for at least 3 seconds.

Any existing water is drained out before the door can be

opened.

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with

respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer

to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.

The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also

“Troubleshooting Guide” in your Instructions for Use).

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

** Reference Programmes for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.

CONSUMPTION DATA

Power consumption in off-mode 0.11 W / in left-on mode 0.11 W

Programme

Temperature

(°C)

Load

(kg)

Water

(l)

Energy

without

“Rapid”

(kWh)

Approx. Programme Duration

(hours : minutes)

without “Rapid” with “Rapid”

Cotton 95 6.5 55* 2.00 2:35 2:00

Cotton 60 6.5 51 1.23 2:30 1:45

Cotton 40 6.5 51 0.62 2:25 1:30

Jeans 40 4.0 41 0.58 1:30 1:10

Synthetics 60 3.0 50* 0.90 2:05 1:14

Synthetics 40 3.0 46 0.50 1:50 0:59

Delicate 40 1.5 50 0.55 0:45 -

Delicate 30 1.5 50 0.50 0:45 -

Daily load 40 3.0 40 0.45 1:00 -

Speed 15’ 30 3.0 30 0.15 0:15 -

Wool/Handwash 40 1.0 40 0.55 0:35 -

Wool/Handwash Cold 1.0 40 0.10 0:35 -

eCotton ** 60 6.5 51 0.85 3:30 -

eCotton ** 60 3.25 35 0.72 2:45 -

eCotton 40 6.5 51 0.65 2:30 -

eCotton ** 40 3.25 35 0.49 2:00 -

5019 300 00883

Whirlpool is a registered trademark of Whirlpool USA.

Whirlpool AWE 9633 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool AWE 9633

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info