Bedienungsanleitung Whirlpool AWO 726 (Seite 2 von 2) (Englisch)

71894

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 301 01027

Whirlpool is a registered trademark of Whirlpool USA.

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

Cotton

95 6,0 59 * 1.90 2:00

Cotton **

60 6,0 49 1.14 2:20

Cotton

40 5.0 56 0.70 2:00

Synthetics

60 2.5 50 * 0.80 1:35

Synthetics

40 2.5 46 0.50 1:20

Delicates

30 1.5 60 0.50 0:45

Quick wash

30 3.0 41 0.40 0:30

Wool

40 1.0 60 0.50 0:45

Handwash

40 1.0 45 0.50 0:40

Handwash

30 1.0 45 0.40 0:36

Add detergents as indicated on the front page

and as described in your Instructions for Use.

Close the door and turn the programme

selector to the desired programme and

temperature. The indication lamp next to the

“Start/Pause” button blinks.

CONSUMPTION DATA

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456.

Consumption data in the h

ome may vary with respect to the values in the table in relation to the water supply pressure

and temperature, the load and the type of wash.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains

the water out.

** Reference Programme for Energy Label.

ADD DETERGENTS, CLOSE THE DOOR

AND SELECT THE PROGRAMME

“DOOR OPEN” INDICATION

Before starting and after end of a programme,

the lamp lights to show the the door can be

opened. As long as a wash programme is

running, the door remains locked and must on

no account be forced open. In case you have

an urgent need to open it during a running

programme, refer to “Cancel (Reset) a running

programme before the end”.

RED INDICATIONS

“Service”

Lighting up of the “Service” indication can be

caused by a fault in an electrical component.

Refer to the “Troubleshooting Guide” in your

“Instructions for Use”; if the fault persists,

contact our After Sales Service.

“Water tap closed”

The appliance has no or insufficient water

supply. Open the water tap: if the indications

still lights up, refer to the “Troubleshooting

Guide” in the Instructions for Use.

“Clean pump”

Waste water is not pumped out. Check

whether the drain hose is kinked or the filter

must be cleaned: in the latter case refer to the

Instructions for Use (“Removing the Filter”).

“Intensive rinse” button

• More water is added and rinse cycle is

prolonged.

• This option is particularly suitable for areas

with very soft water, washing baby linen and

helps people with allergies.

“Spin speed reduction” button

• Reduces the predermined automatic

maximum spin speed to treat your laundry

more gently.

PROGRAMME START

Open the tap and press the “Start/Pause”

button. The indication lamp next to the

“Start/Pause” button lights up. The

programme sequence indicator shows the

current programme phase, running from left to

right through Wash, Rinse, Spin/Drain.

When the programme phrase is finised, the

corresponding indication goes out.

PROGRAMME END

• All the lights of the programme sequence

indicator are off, and the “Door open”

indication lights up.

1. Turn the programme selector to the “Off/O”

position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

1. Press the “Start/Pause” button to pause

the programme. The light blinks.

2. Select the new programme (with

temperature), any options and another spin

speed if you want.

3. Press the “Start/Pause” button again.

The new programme continues at the same

position where the previous programme

was interrupted. Do not add detergent for

this programme.

CANCEL (RESET) A RUNNING PROGRAMME

BEFORE THE END

The “Reset” button cancels a programme

before the end.

•

Press the “Reset” button for at least 3

seconds

Any existing water is drained out before the

door can be opened.

SELECT ANY DESIRED OPTION

Push the button(s) of any option(s) desired - the

respective indication lamp lights up.

When the combination of programme and

additional option(s) is not possible, the

indication lights switch off automatically.

Unsuitable combinations of options are

deselected automatically.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool AWO 726 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool AWO 726

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info