PRECAUTIONS AND GENERAL RECOMMENDATIONS
The packing box may be fully recycled as
confirmed by the recycling symbol .
2. Energy saving tips
Always dry a full load: depending on the type of
laundry and the programme/drying time.
By preference use the maximum spin speed allowed
by your washing machine, since draining the water
mechanically requires less energy. You will save
time and energy when running your drying cycle.
Do not overdry the laundry.
Clean the lint filter after
Place your dryer in a room with a temperature
between 15° C and 20° C. In case of higher
temperature ventilate the room.
Always select the correct programme/drying time
for the load in order to obtain the desired drying
Select the gentle option only with small loads.
When drying cotton, for example. dry iron dry and
cupboard dry loads together. Start with the iron dry
programme/drying time setting, remove the
laundry to be ironed at the end of that cycle and
dry the remainder of the load on the cupboard dry
3. Disposing of packaging and old Dryer.
The dryer is built from reusable materials. The
dryer must be disposed of in compliance with local
waste disposal regulations.
Before scrapping, cut off the power cable so that
the dryer cannot be connected to the mains.
4. Child safety:
Children must not be allowed to play with the
5. General recommendations:
Always set the programme/time selector knob to
the “0” position after use.This prevents the dryer
from being switched on accidentally.
Before cleaning or carrying out maintenance,
switch off the dryer and disconnect it from the
To clean the outside of the dryer, use a neutral
detergent and a damp cloth.
Do not use abrasive detergents.
Wipe away lint from the door seal and the door
using a damp cloth.
If the lint filter mesh is clogged, clean it with
water and a soft brush.
Since lint can go through the filter it is necessary
to clean, from time to time, the complete filter
area (including below the filter) with a brush, a
damp cloth or with a vacuum cleaner.
If necessary, the power cable may be replaced with
an identical one obtained from our After-Sales
Service. The power cable must only be replaced by
a qualified technician.
EC Declaration of Conformity
This dryer has been designed, constructed and
distributed in compliance with the safety
requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive.
The dryer must only be used in the household for
the prescribed uses.