Bedienungsanleitung Whirlpool W6XW845WBEE (Seite 4 von 5) (Englisch)

756818

Zoom out

Zoom in

Vorherige Seite

1/5

Nächste Seite

Use low temperature and longer duration

The most ecient programmes in terms of energy consumption are

generally those that perform at lower temperatures and longer duration.

Observe the load sizes

Load your washing machine up to the capacity indicated in the

“PROGRAMME CHART” table to save water and energy.

Noise and remaining moisture content

They are inuenced by the spinning speed: the higher the spinning speed

in the spinning phase, the higher the noise and the lower the remaining

moisture content.

CARE AND MAINTENANCE

Before performing cleaning and maintenance, switch the washing machine

o and disconnect it from the mains power. Do not use ammable liquids to

clean the washing machine. Clean and maintain your washing machine

periodically (at least 4 times per year).

Disconnect the water and power supplies

Close the water tap after every wash. This will limit wear on the hydraulic

system inside the washing machine and help to prevent leaks.

Unplug the washing machine when cleaning it and during all

maintenance work.

Clean the washing machine

The outer parts and rubber components of the appliance can be cleaned

using a soft cloth soaked in lukewarm soapy water. Do not use solvents or

abrasives.

Clean the detergent dispenser drawer

Wash it under running water; this operation should be repeated

frequently.

Care for the door and drum

Always leave the porthole door ajar in order to prevent unpleasant odours

from forming.

Check the water inlet hose

Check the water inlet hose at least once a year. If it is cracked or broken, it

must be replaced: during wash cycles, the high pressure of the water

could suddenly split the hose open.

! Never use hoses that have already been used.

Cleaning the drain pump lter / draining residual water

Switch o and unplug the washing machine, before cleaning the drain pump

lter or draining residual water.

If you used a hot wash programme, wait until the water has cooled down before

draining any water. Clean the drain pump lter regularly, to avoid that the

water cannot drain after the wash due to obstruction of the lter. If the water

cannot drain, the display indicates that the drain pump lter may be clogged.

1. Power O and unplug the washing machine from the electrical outlet.

2. Gently press the top area of the lter cover to open.

3 . Place a container close to the pump to collect any spillage.

4. Stretch the “emergency drain hose” to the container.

5.Turn the stopper of the “emergency drain hose” at the end of the hose and

let the water ow into the container.

6 . Turn the exhaust lter handle and pull it out of the housing .

When the container is full with water, plug the stopper to the hose end, and

reinsert the small hose in the washing machine’s base . After, empty the

container .

Afterwards rmly close the emergency drain hose with the stopper .

7. Remove lter: Lay a cotton cloth beneath the drain pump lter, which

can absorb a small amount of water . Then remove the drain pump lter by

turning it out anticlockwise .

8 . Clean the drain pump lter: remove residues in the lter and clean it

under running water .

9 . Insert the drain pump lter: Reinsert the drain pump lter again by

turning it in clockwise direction . Make sure to turn it in as far as it goes; the

lter handle must be in vertical position . To test water tightness of the drain

pump lter, you can pour about 1 liter of water into the detergent dispenser

ACCESSORIES

Contact our Technical Assistance Service to check whether the following

accessories are available for this washing machine model.

Stacking kit

With this accessory you can secure the tumble dryer to the upper part of

your washing machine to save space and facilitate loading and unloading

of the tumble dryer.

TRANSPORT AND HANDLING

Do not lift the washing machine by gripping it from the upper section.

Unplug the appliance and close the water tap. Check that the door and

detergent dispenser drawer are tightly closed. Detach the lling hose

from the water tap then detach the drain hose. Empty all the water

remaining in the hoses and secure the latter so that they do not get

damaged during transport. Apply the transport bolts back on. Repeat, in

reverse order, the transport bolt removal procedure described in the

“Installation instructions”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool W6XW845WBEE Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool W6XW845WBEE

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info