Bedienungsanleitung Whirlpool WIO 3T133 (Seite 6 von 8) (Englisch)

652504

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

LOADING THE RACKS

CUTLERY RACK

The third rack was designed to house the

cutlery.

Arrange the cutlery as shown in the figure.

A separate arrangement of the cutlery

makes collection easier after washing and

improves washing and drying

performance.

Knives and other utensils with sharp edges must be positioned

with the blades facing downwards.It must only be positioned at

the front of the lower rack.

The geometry of the rack makes it

possible to place such small items as

coffee cups in the area in the middle.

The cutlery basket is equipped with two

sliding side trays to make the most of

the height of the space below and ena-

ble the loading of high items into upper

rack.

UPPER RACK

Load delicate and light dishes: glasses, cups, saucers, low salad bowls.

(loading example for the upper rack)

ADJUSTING THE HEIGHT OF THE UPPER RACK

The height of the upper rack can be adjusted: high position to place

bulky crockery in the lower basket and low position to make the most

of the tip-up supports by creating more space upwards and avoid

collision with the items loaded into lower rack.

The upper rack is equipped with a

Upper Rack height adjuster

(see figure), without pressing the levers,

lift it up by simply holding the rack

sides, as soon as the rack is stable in its

upper position.

To restore to the lower position, press

the levers A at the sides of the rack and

move the basket downwards.

We strongly recommend that you do

not adjust the height of the rack

when it is loaded.

NEVER raise or lower the basket on one side only.

FOLDABLE FLAPS WITH ADJUSTABLE POSITION

The side foldable flaps can be positioned at three

different heights to optimize the arrangement of

crockery inside the rack.

Wine glasses can be placed safely in the foldable

flaps by inserting the stem of each glass into the

corresponding slots.

For optimum drying results incline the foldable

flaps more. To change the inclination, pull up the

foldable flap, slide it slightly and position it as

you wish.

LOWER RACK

For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids

should ideally be placed at the sides to avoid interferences with the

spray arm.

(loading example for the lower rack)

The lower rack has tip-up supports which can be used in a vertical

position when arranging plates or in a horizontal position (lower) to

load pans and salad bowls easily.

POWER CLEAN IN LOWER RACK

Power Clean® uses the special water jets in

the rear of cavity to wash more intensively the

high dirty items. The lower rack has a Space

Zone, a special pull-out support in the rear of

the rack that can be used to support frying

pans or baking pans in upright position, thus taking up less space.

Placing the pots/casseroles faced to the Power Clean® component

please activate the POWER CLEAN on the panel.

How to use Power Clean®:

1. Adjust the Power Clean®

area

folding down the rear

plate holders to load pots.

2. Load pots and casseroles

inclined vertically in Power

Clean® area. Pots have to be

inclined towards the power

water jets.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WIO 3T133 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WIO 3T133

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info