FINDKNSGRIPENLFGBD
Freezer inside temperature adjustment
The appliance is normally factory-set for operation at the recommended temperature of -18°C.
C.The inside temperature setting can be adjusted between -16°C and -24°C, proceeding as follows:
• Press the inside temperature adjustment button D. The storage temperature can be changed by -1°C
with each press of the button: the value flashes cyclically between -16°C and -24°C.
• The 6th Sense function is activated automatically in case of opening of doors and the introduction of
small amounts of food to be frozen. Its duration is variable and depends on the product load conditions
and the outside temperature. It does not require any intervention by the user and switches off
automatically when normal operating conditions are restored.
The Eco Night function enables appliance energy consumption to be concentrated in the reduced rate
hours (generally at night), when electricity is readily available and costs less than during the daytime (only
in countries that utilise a time based multi-rate system - check energy rates with the local electricity
company).
To activate the function, press the button F at the reduced rate start time (depending on the specific rates
plan). For example, if the reduced rate starts at 8 p.m., press the button F at that time. When the Eco
Night LED is ON, the function is on.
Once the function is activated, the appliance automatically adapts energy consumption according to the
time selected, i.e. consuming less energy during the day than at night.
IMPORTANT: To operate properly, the function must be on during the night and day.
The function remains on until deactivated (or it is deactivated in case of a power failure or appliance
switch-off). To deactivate the function, press the button F again. When the Eco Night LED is OFF, the
function is off.
Note: The declared appliance energy consumption refers to operation with the Eco Night function
deactivated.
ECO NIGHT FUNCTION (NIGHTTIME RATE)
This optional function can be used to save energy. To activate the Eco mode, press the buttons F and J
together for 3 seconds until an audible signal sounds. Two seconds after activation of the Eco mode, the
display goes off, except the "6th Sense" icon (and the audible signal is deactivated, if on). To adjust the
temperature or use other functions, it is necessary to activate the display by pressing any button. After
about 15 seconds without performing any action, the display goes off again and only the "6th Sense" icon
remains visible. To deactivate this function, press the buttons F and J together for 3 seconds until an
audible signal sounds. The normal display is restored. The Eco mode is automatically disabled after a
power failure or a fault alarm. Remember that this function does not disconnect the appliance from the
power supply.
ECO MODE
