774230
61
Zoom out
Zoom in
Vorherige Seite
1/64
Nächste Seite
English
13
IMPORTANT INFORMATION
If the motor is dragged to a low speed since the food is too thick or there
is too less liquid in the jar, and operates for a prolonged period, the
temperature monitoring system will trigger and stop the operation of the
motor. In this case, switch off and put the blender to a place with good
ventilation to cool down the motor temperature for approx. 35 minutes.
The system will reset and the blender can be used again.
During operation, close the lid tightly to avoid scalding due to spraying of
hot liquids.
Keep hands and utensils out of the container while the motor is running to
prevent the possibility of severe personal injury and/or damage.
When making hot beverage such as soybean milk, hot soup, please check
whether the lid is secured tightly to the jar to prevent it from falling. It is
advisable to start the operation at low speed setting and then increase the
speed gradually, or use the Pulse Drive mode.
When making sauces (e.g. almond sauce, jam and sesame sauce), stuffing
and nuts, put in between 2 and 3 cups of ingredients. The amount should
neither be too large or too little. Keep the blending time below 2 min. to
prevent any burnt smell due to overheating. Too much ingredients may lead
to overloading and overheating of the motor. In this case, wait till the motor
temperature falls before operating again.
Please put liquid and soft food before putting in hard food or ice cubes.
When the operation finishes, please wait until the blade assembly comes to
a complete stop before taking up the blender jar.
If you feel a scorch smell from the blender, stop the operation immediately.
It may be caused by the abrasion at the rubber cushion base if it is not
properly assembled.
When blending thick and sticky food using high speed, please start the
operation at low speed. If the turning is still idle, disconnect the power and
stir the blender jar using a rubber stirrer to drive out the air capsule trapped
in the food. Then close the lid and switch on to proceed the operation.
Do not operate for more than 10 minutes at a time.
TECHNICAL SPECIFICATIONS
Model No. BPFD-1680MB, BPFD-1680MW
Voltage / Frequency 220-240V ~ 50-60Hz
Rated Power 1680 W
Dimensions (H) 430mm (W) 205mm (D) 174mm
Net Weight 4.3kg
61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Wilfa BPFD-1680MB - Power Fuel Digital wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Wilfa BPFD-1680MB - Power Fuel Digital

Wilfa BPFD-1680MB - Power Fuel Digital Bedienungsanleitung - Deutsch, Holländisch, Französisch, Polnisch - 52 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info