Bedienungsanleitung Wilfa PB-1600S - Power Crush (Seite 35 von 39) (Englisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

774239

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

12 13

English

Operating instructions

Designed for processing liquids including juice, frozen mixtures, sauces, soups,

purees, batters, and for wet chopping.

1. Make sure that the variable speed control is set to OFF position.

2. Load the container before placing in on the motor base. Place liquids and soft

foods in the container ﬁrst, solid items and ice last. Although not necessary for

blending, you may want to cut or break food into smaller pieces for more precise

measuring of ingredients.

3. Attach the lid properly. Always use the complete lid when blending (unless the

tamper is inserted through the lid plug opening). Especially when blending hot

ingredients, make sure the lid is securely latched.

4. With the motor is off, set the wet blade container on the motor base by aligning

it over the centering pad.

Do not attempt to put a container on an operating motor base or to operate a

motor base without a container properly in place.

5. Activate the machine by turning the ON/OFF (Pos.O/I) Switch to ON (Pos.I),

always start your machine on OFF position and then slowly increase to the

desired speed.

6. Be extremely careful when handling and processing hot ingredients and

making hot soups and sauces.

7. Due to the machine’s speed, processing times are much quicker than standard

appliances. Until you are familiar with the machine, count your time carefully to

avoid over processing.

8. After turning the machine off, wait until the blades completely stop before

removing the lid or container from the motor base.

Blending quantities and processing times

Ingredients Blending quantity Time

Carrot e.g. 800g carrot + 1200ml water 30 sec

Care and cleaning

Container

To prepare you new machine for initial use, follow the steps below. This will clean

the unit. Fill the container half full with warm water and add a couple drops of liquid

dish washing detergent to the container.

1. Snap or push the complete 2-part lid into locked position.

2. Turn on the machine and slowly increase the speed to speed MAX.

3. Run the machine on High speed for 30 to 60 seconds.

4. Turn off the machine, and rinse and drain the container.

Lid, Lid Plug and Tamper

Separate the lid and lid plug. Wash the parts in warm soapy water. Rinse clean

under running water, and dry. Reassemble before use. Lid, lid plug and tamper are

dishwasher safe.

Motor Base

1. Unplug the power cord.

2. Wash the outside surface with a damp soft cloth or sponge, which has been

rinsed in a mild solution of liquid detergent. Do not place the motor base in

water.

3. Thoroughly clean the switches so they work freely. They may become sticky

from use. Use a moistened cotton swab to clean the grooves around the water-

shielded switches. Immediately dry any excess water.

4. Polish with a soft cloth.

Warning: Electrical shock hazard.

Disconnect power before cleaning machine. Failure to follow instructions can cause death or

electrical shock.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wilfa PB-1600S - Power Crush Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info