Bedienungsanleitung WLtoys V606 EXPLORERS (Seite 7 von 8) (Englisch)

609005

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

This model can be equipped with a camera. If your model

doesn't include it, you can find it from your retailer or on

www.wltoys.eu. The camera is installed as explained under

module. You can install the SD card by pushing it in the rear slot

until you hear a click. To take out, press again till it is pushed

out.

To take a picture press the foto button. To record a video press

the video button. Make sure to start AND stop your video

recording. When it is not stopped the recording will not be saved

propperly.

Your camera comes with a USB stick. Insert the SD card into

the USB and then insert into a computer USB slot.

On your computer open de folder of the USB drive. You will find

the follwing folders:

PHOTO > Contains all photo images

VIDEO > Contains all video's

Imported by: WLtoys.eu / DroneX BV

Bloemstraat 86HS 1016 LE Amsterdam | www.wltoys.eu |

info@wltoys.eu

Our products comply with the standards and criteria of the

European Union and approved by the EC. For your safety, we

recommend that you read the entire manual before your first

flight.

Spare parts

Wltoys

1. The receiver LED blinks continuously for more than 4 seconds after the quadcopter battery have been inserted. No response to

the command input. The transmitter is not connected to the device. Repeat the power-on initialization process.

2. No response from the quadcopter after the battery have been connected. There is probably contact failure on the battery

terminals. Turn on the transmitter and ensure that the battery of the vehicle is correctly inserted. Replace the battery and ensure

good contact at the battery's connections. Use fully charged batteries in the remote.

3. The motor does not respond to the throttle stick and the receiver flashes. The quadcopter's battery is exhausted. Charge the

battery or replace it with a charged battery.

4. The main rotor continues to rotate after landing. Confirm that the gear lever is oriented downward.

5. The main rotor rotates but the device does not take off. The blades may be distorted or the quadcopter battery is exhausted.

Charge or replace with a fully charged battery and / or replace the blades.

6. The quadcopter suffers of strong vibrations. The blades are distorted. Replace the blades.

7. The tail is not balanced after adjusting the clip or speed is inconsistent in the left / right pirouette. Tail rotors are probably

damaged. Replace the main wing and / or the main engine.

8. The quadcopter was still moving forward after the adjustment of the levers during hover. The gyroscope is not correctly

calibrated. The gear lever is placed too high or too low. The boot refines the calibration therefore restart on a flat surface.

9. You can not fly, the helicopter falls. The motor is probably fall out or the gears are loose. Reinstall the motor and tighten the

gears.

The copter is not sensitive to crashes, but in case of extreme drops it is possible that some parts may break. All parts can be

ordered and easily assembled. Please contact your dealer or visit www.wltoys.eu for more information.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WLtoys V606 EXPLORERS Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von WLtoys V606 EXPLORERS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info