Bedienungsanleitung WOLF-Garten SDE 2800 EVO (Seite 12 von 98) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

523453

Zoom out

Zoom in

Vorherige Seite

1/98

Nächste Seite

Working with the garden chopper

Wear protective gloves and hearing protection!

Adopt a working position at the side of or behind the appliance.

Never stand in the area of the discharge opening.

Never put your hands in the feed or discharge opening.

Before switching on the appliance check whether there is any

chaff in the hopper.

If foreign bodies should enter the hopper or should the appliance

make unusual noises or vibrations, switch the appliance off im-

mediately and allow it to come to a standstill. Remove the mains

plug and carry out the following:

–

Check the appliance and tighten any loose parts.

–

Replace damaged parts.

–

Repairs to the appliance must be performed by an authorised

service centre.

What can be chopped

Organic waste from the house and garden e.g. hedge and tree

cuttings, dead flowers, kitchen scraps.

What cannot be chopped?

Glass, metal parts, plastics, plastic bags, stones, material waste,

roots with earth, food, fish and meat waste

Switching on / off

Press the green button to switch on

(2)

Press the red button to switch off (3)

The machine has a circuit breaker to prevent switching

back on unintentionally after a power cut.

Overload protection

An overloading of the appliance (e.g. culminating in the

blocking of the blades) can lead to the standstill of the ap-

pliance after a few seconds. To protect the motor from da-

mage the appliance is automatically disconnected from

the mains by the overload protection.

Before putting into operation again wait for at least one mi-

nute before immediately pressing the reset button (1)

and then ON/OFF switch. If the motor does not start, clean

the collection hopper (see Maintenance).

Special instructions for chopping

Chop branches, twigs and wood shortly after cutting (this chop-

ped material will become very hard once it has dried out, therefo-

re the maximum diameter which can be processed is less).

Remove the side shoots on severely ramified branches.

When processing garden or kitchen waste with a high water con-

tent with a tendency to stick, crush alternately with wooden chop-

ping material to avoid blocking the appliance.

Do not allow the chopping material in the area of the discharge

opening to accumulate too high. This can lead to material which

is already chopped blocking the discharge channel. This can

cause a kickback of the material through the filling opening.

Ensure that the maximum branch diameter for processing permit-

ted for your appliance is observed.

The blade unit pulls in the chopping material largely by itself.

Do not overload or block the motor in the case of tough branches

by frequently pulling back the branch.

Maintenance

General

Remove the mains plug before any maintenance and

cleaning work!

When servicing the cutting tool ensure that it can still al-

ways run on even when the motor is switched off.

Wear protective gloves.

Store the appliance in a dry location out of the reach of children.

General cleaning information

Remove the mains plug before any maintenance and

cleaning work!

Handle the appliance with care and clean it regularly to prolong

its service life.

Keep the ventilation slits clean and dust-free.

Only use a warm and moist cloth to clean the appliance as well

as a soft brush.

Do not allow the appliance to get wet and do not spray with water.

Cleaning the collection hopper

Remove the mains plug before any maintenance and

cleaning work!

1. Unscrew the knob and fold the casing upwards to open .

2. Clean the cutting and discharge area of all objects which could

block the blades.

3. Close the casing again and tighten the knob .

4. Press the reset button before activating the ON/OFF switch.

Safety locking device

The chopper is equipped with a safety locking device at the lock

between the casing and the motor casing.

In the event that the casing does not close flush to the motor ca-

sing, the motor is stopped by the safety locking device.

In such a case, proceed as follows:

–

Unscrew the knob and fold the casing upwards to open .

–

Carefully clean the contact surfaces.

–

Close the casing again and tighten the knob .

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten SDE 2800 EVO Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info