684723
20
Zoom out
Zoom in
Vorherige Seite
1/22
Nächste Seite
10
EN
becoming too low. The pre-warning will switch off if the pre-set
disconnect voltage is reached or if the input voltage has risen to
13.0/26.0Volts. The maximum load is 100mAmp.
With this contact, it is also possible to automatically set a relay, with
which for example, a generator could be started. In this case it is
important that a diode (e.g. 1N4007) is mounted over the coil of the
respective relay.
THE DISCONNECT VOLTAGE
The disconnect voltage required can be set using the 'mode' push
button. The lower the voltage, the more deeply the battery is
discharged. Which setting should be selected depends primarily on the
usage situation. In order to still be able to start a vehicle, a high
disconnect voltage will need to be selected. Secondly, the point of
disconnect depends on the type of battery. Some types and brands of
battery may be discharged more deeply than others. Full-traction
batteries for example, have been specifically developed to be deeply
discharged (heavy cyclic use). Where possible discuss the correct
switching voltage with your battery supplier.
Pre-set disconnect voltage
Make sure the protector is connected to the battery. The consumer
does not need to be connected at this stage. The protector can only be
set if the status LED is green or red (lights up or flashes).
Press and hold the 'mode' button for 5 seconds. The LED ‘status’ will
be off during this time. Release the button when the LED lights up again.
The protector is in the setting procedure and will immediately display
the current setting. By briefly pressing the mode button in quick
succession, a selection can be made from the different settings. These
are distinguished by the LED colour and whether or not the LED light is
flashing. See following diagram.
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Xenteq SBP-SERIES wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info