Bedienungsanleitung XtremeMac Tango TRX (Seite 4 von 33) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

496946

Zoom out

Zoom in

Vorherige Seite

1/33

Nächste Seite

ImPortant saFetY InstructIons

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water - This apparatus shall not

be exposed to dripping or splashing, and no objects ﬁlled with

liquids, such as vases, shall be placed on the apparatus.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance

with the manufacturer’s instructions. The apparatus should

not be situated on a bed, sofa, rug or similar surface that may

block the ventilation openings.

8. Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including ampliﬁers) that

produce heat.

9. No naked ﬂame sources, such as lighted candles, should be

placed on the apparatus.

10. Protect the power cord from being walked on or pinched—

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

11. Do not install in an area which impedes the access to the

power plug. Disconnecting the power plug is the only way to

completely remove power to the product and must be readily

accessible at all times.

12. Power source—Use only the power supply that is included

with this unit. Do not substitute with any other power supply.

13. Unplug this apparatus during lightning storms or when

unused for long periods of time.

14. Refer all servicing to qualiﬁed service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not operate

normally, or has been dropped. For service, refer to qualiﬁed

service personnel, return to the dealer, or call the XtremeMac

service line for assistance.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This class B digital apparatus complies with Canadian ICES-003.

Note: Changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

gettIng starteD

1. Remove unit, AC adapter and remote from the box and

properly dispose of any plastic or foam packaging material.

2. Place unit on a level surface close to a power outlet following

the precautions listed in the safety warnings.

3. If located in the US, skip to step 6. If located outside the US,

select the appropriate wall adapter. If already attached to the

unit, skip to step 6.

4. Press the button labeled "open" under the wall adapter to

release the adapter.

5. Gently slide in the appropriate wall adapter. You will hear a

click when it is properly locked into place.

6. Connect the AC adapter jack to the back of the unit labeled

power and then connect the other end of the adapter to a

power outlet.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

XtremeMac Tango TRX Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info