674722
44
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
DR-2X / DR-2XE Operating Manual42
19. Remote Operation with External Controller
Repeater operation may be controlled remotely by connecting an external controller through the
[
CONTROL
I/O
]
connector at the back of the repeater.
The following features are available while in remote operation:
Change the communication mode of repeater transmit and receive
Turn the RX and TX tone signal “ON” or “OFF”
Monitor the discriminator analog or demodulated digital audio during up-link reception
To use the repeater under remote control, set up the repeater as explained below, after it is connected to the
external controller.
Turning remote operation ON/OFF
When the remote operation is “ON”, the repeater operates according to the control instructions received from
the external controller (the instructions are received through Pin 11 to Pin 14 of the
[
CONTROL I/O
]
connector).
When the remote operation is “OFF”, the repeater operates according to the settings determined through the
setup mode.
1 Touch
[
A SETUP
]
.
The setup mode screen will appear.
2 Touch
[
F
]
.
The setup menu will appear.
3 Touch
[
MODE/REMOTE
]
.
The menu list will appear.
4 Touch
[
REMOTE
]
.
The set value will change between
[
OFF
]
and
[
ON
]
each time
[
REMOTE
]
is touched.
z Factory default: OFF
z Remote operation is available only on the CH-A.
z Remote operation is not available in the “HRI + REPEATER MODE”.
M/V
BACK
BACK
>
ON
ON
REMOTE
COMMAND
DISPLAY TIMER
REMOTE/COMMAND/DISP TIMER
5 Touch
[
BACK
]
3 times.
The setting is determined and the display will return to the operation mode screen.
Note that
[
REMOTE
]
at the bottom left of the screen is displayed in red.
You can transmit by the microphone and PTT input of the front panel in all settings except AMS/AMS.
Control from external controller
To control the DR-2X/DR-2XE remotely, optional cables can be used
to connect the repeater to an external controller.
Use the “CONTROL I/O” connector at the back of the repeater to con-
nect with the external controller.
To interface the DR-2X/DR-2XE with an external controller, additional
cables with a 15-pin mini d-sub connector are needed to connect to
the “CONTROL I/O” connector. Your controller may also require rewir-
ing.
Link operation may require four connections: receiver audio, transmit-
ter audio, receiver COR, and transmitter PTT; however, these are not
available on the “CONTROL I/O” connector.
The pin assignment of the “CONTROL I/O” connector is as follows.
Do not use a VGA cable for PC display to connect the external controller
to the repeater.
CONTROL I/O connector
5~1
10~6
15~11
(as viewed from real panel)
44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu DR-2X wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info