Bedienungsanleitung Yaesu FT-450 (Seite 14 von 104) (Englisch)

444588

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

Page 12 FT-450 OPERATION MANUAL

NSTALLATION

GROUNDING

The FT-450 transceiver, like any other HF communications apparatus, requires an effective ground system for

maximum electrical safety and best communications effectiveness. A good ground system can contribute to

station efficiency in a number of ways:

 It can minimize the possibility of electrical shock to the operator.

 It can minimize RF currents flowing on the shield of the coaxial cable and the chassis of the transceiver.

Such currents may lead to radiation, which can cause interference to home entertainment devices or

laboratory test equipment.

 It can minimize the possibility of erratic transceiver/accessory operation caused by RF feedback and/or

improper current flow through logic devices.

An effective earth ground system may take several forms. For a more complete discussion, see an appropriate

RF engineering text. The information below is intended only as a guideline.

Typically, the ground connection consists of one or more copper-clad steel rods, driven into the ground. If

multiple ground rods are used, they should be positioned in a “V” configuration, and bonded together at the apex

of the “V” which is nearest the station location. Use a heavy, braided cable (such as the discarded shield from

type RG-213 coaxial cable) and strong cable clamps to secure the braided cable(s) to the ground rods. Be sure

to weatherproof the connections to ensure many years of reliable service. Use the same type of heavy, braided

cable for the connections to the station ground bus (described below).

Inside of the station, a common ground bus consisting of a copper pipe of at least 25 mm (1”) diameter should

be used. An alternative station ground bus may consist of a wide copper plate (single-sided circuit board material

is ideal) secured to the bottom of the operating desk. Grounding connections from individual devices such as

transceivers, power supplies, and data communications devices (TNCs, etc.) should be made directly to the

ground bus using a heavy, braided cable.

Do not make ground connections from one electrical device to another, and thence to the ground bus. This so-

called “Daisy-Chain” grounding technique may nullify any attempt at effective radio frequency grounding. See

the drawing below for examples of proper grounding techniques.

Inspect the ground system - inside the station as well as outside - on a regular basis so as to ensure maximum

performance and safety.

Besides following the above guidelines carefully, note that household or industrial gas lines must never be used

in an attempt to establish an electrical ground. Cold water pipes may, in some instances, help in the grounding

effort, but gas lines represent a significant explosion hazard, and must never be used.

Linear

Amp lifier

TNC

Trans ceiver

Linear

Amp lifier

TNC

Trans ceiver

"Daisy Chain"

PROPER GROUND CONNECTION

IMPROPER GROUND CONNECTION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yaesu FT-450 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info