478499
71
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
69FT-857D Operating Manual
A
CTIVE
-T
UNING
A
NTENNA
S
YSTEM
(
ATAS-100/-120
)
O
PERATION
TRANSMITTER OPERATION
6. When you wish to conclude ATAS-100/-120 operation, press the
[
A
](
TUNE
)
key; the
” icon disappear surrounding the “ATAS” indication.
If the ATAS-100/120 retracts to its minimum length, it will not automatically shut
off instantly; it may continue to have its motor engaged for as long as 30 seconds
thereafter, until a timer expires. A clutch mechanism prevents damage to the antenna
while this is happening, and this condition is completely normal.
Manual Tuning
In some instances, the SWR may be slightly improved by manual adjustment of the antenna
position. This may be needed for operation on bands like 40 meters, where the “Q” of the
ATAS-100/-120 is high, causing a narrow resonance range.
To tune the ATAS-100/-120 manually, recall Multi Function Row “k”
[
TUNE, DOWN,
UP
]
, then press and hold in the microphone PTT switch. With the transceiver in the “trans-
mit” mode, press and hold in the
[
C
](
UP
)
key (to raise the antenna) or the
[
B
](
DOWN
)
key
(to lower the antenna). While you hold in one of these keys, the FT-857D will generate a
carrier, and you may watch the top scale of the FT-857s meter, looking for the meter
indication to reach its minimum value. When this is reached, release the
[
C
](
UP
)
or
[
B
](
DOWN
)
key, then release the PTT key to return to the “receive” mode.
R.F. Says: 1) Once automatic matching has been successfully accomplished, you
must change frequency by at least 10 kHz before attempting automatic matching
again. Within a window of ±10 kHz from a match point, the transceiver’s microprocessor
will ignore any command to attempt automatic matching.
2) Antenna tuning is accomplished using a “CW” carrier, although the mode indication
will not change to “CW” (if you are operating on another mode) during antenna tuning.
3) If you see a “HSWR” on the LCD, it may mean that there is a problem in your coaxial
cable (bad connection, etc.) which is preventing successful tuning. Replace the cable, or
try adding a few feet/meters of cable (to eliminate the possibility of adverse “transformer
action” in the 50 cable during the tuning process).
4) If you are able to achieve an SWR of less than 2:1 via manual tuning, the FT-857D
will “accept” the manual setting, and you may then re-tune automatically when chang-
ing bands. If, however, you stop manual tuning at a non-optimum setting (SWR >2:1),
the FT-857D “will not permit further automatic tuning. To refresh the setting of the
ATAS-100/-120, press the
[
B
](
DOWN
)
key until the ATAS-100/-120 fully retracts. You
may then restart automatic tuning per the procedures described earlier.
5) The FT-857D may also be used with the model ATAS-100 antenna, although the tun-
ing speed of the ATAS-100 will be about 20% slower than with the ATAS-120.
71

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT-857D wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info