674747
79
Zoom out
Zoom in
Vorherige Seite
1/140
Nächste Seite
Page 77
FT
DX
1200 OPERATING MANUAL
The powerful CW operating capabilities of the
FT
DX
1200
permit operation using an electronic keyer paddle, a “straight
key”, or a computer-based keying device.
SETUP FOR STRAIGHT KEY
(
AND STRAIGHT KEY EMULATION
)
OPERATION
Before starting, connect your key lines) to the front andor rear panel
KEY
jacks). Be sure the
[
BK-IN
]
button is
turned off for now.
1. 3ress the
[
MODE
]
button to engage CW operation.
The “
USB CW
icon will appear in the display. The
MONI
” icon will appear in the TFT display and the
CW monitor is activated.
A
DVICE:
If you press and hold the
[
MODE
]
button, you will
engage the “CW 5everse” mode, whereby the “op-
posite” sideband injection is used, compared to the
“normal” sideband. The “
LSB CW
icon will ap-
pear in the display if you select CW 5everse.
. 5otate the 0ain Tuning 'ial knob to select the de-
sired operating freTuency.
3. 3ress the
[
BK-IN
]
button to engage automatic acti-
vation of the transmitter when you close the CW key.
The “
BK-IN
” icon will appear in the TFT display.
A
DVICE:
When you close your CW key, the transmitter
will automatically be activated, and the CW car-
rier will be transmitted. When you release the
key, transmission will cease, and after a brief
delay, receive will be restored. The delay time is
user-programmable per the discussion on page
83.
$s shipped from the factory, the
FT
DX
1200
T;
5; system for CW is configured for “Semi-
break-in” operation. However, using 0enu item
063 CW BK-IN
”, you may change this setup
for full break-in QS.) operation, whereby the
switching is Tuick enough to hear incoming sig-
nals in the spaces between the dots and dashes of
your transmission. This may prove very useful
during contest and traf¿c handling operations.
4. 2peration using your CW key may now proceed.
A
DVICE:
You may adjust the CW sidetone audio level setting
of 0enu item “
036 MONITOR LEVEL
”.
To adjust the 0onitor level
1) $ctivate the 021I circuitry, if necessary.
) 3ress and hold in the
[
MONI
]
button for one
second to enter the 0enu item “
036 MONITOR
LEVEL
”.
3) 3ress the
[
SELECT
] button
.
4) While keying, rotate the
[
VFO-B/CLAR
]
knob
or press the
S
T
button) to adjust the monitor
level.
) When you are satisfied with the setting, press
the
[
SELECT
]
button, then press the
[
MENU
]
button to save the new setting and exit to normal
operation.
If you set the
[
BK-IN
]
button to 2ff, you may prac-
tice sending CW with the sidetone only, without hav-
ing the signal go out over the air.
If you reduce power via the 0enu item
177 TX
MAX POWER
”, the $LC meter reading will increase
this is normal and does not indicate any problem
whatsoever because increased $LC voltage is being
used to lower the power).
TERMINOLOGY:
Semi-break-in
This is a pseudo-”V2;” mode used on CW, whereby the closure of the CW key will engage the transmitter, and
release of the key will allow the receiver to recover after a short delay. 1o signals will be heard during the spaces
between dots and dashes unless the sending speed is extremely slow).
Full break-in
Full break-in also known as “Full QS.”) involves very fast switching between transmit and receive, incoming
signals may be heard between the dots and dashes as you send them. This allows you to hear a station that sud-
denly starts transmitting on your freTuency, while you are in the midst of a transmission.
CW MODE OPERATION
[
MONI
]
Button
[
BK-IN
]
Button
[
MODE
]
Button
79

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FTDX1200 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info