Bedienungsanleitung Yamaha KX10 (Seite 14 von 16) (Englisch)

29781

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

If your cassette deck fails to operate normally, check the following table. It lists common operating errors and simple

measures which you can take to correct the problem. If it cannot be corrected, or the symptom is not listed, disconnect the

deck’s power cord and contact your authorized YAMAHA dealer or service center for help.

TROUBLESHOOTING

Fault

Tape doesn’t move in recording or

playback.

REC/PAUSE button fails to function.

Sounds become faint and sometimes

inaudible.

Recorded sound is distorted.

Tape is playing back, but no sound is

heard.

Excessive noise.

Excessive wow (wavering of the

sound).

Tape stops in the middle of recording

or playback.

Fails to record.

Search does not operate.

High frequencies in the playback

sound are emphasized and unpleasant

to listen to, and noise level (hiss) is

also high.

Cause

¶ Power plug is not properly plugged in.

¶ End of tape.

¶ Cassette shell is warped or damaged.

¶ No cassette tape is loaded.

¶ Protective tabs are broken off.

¶ Head is dirty.

¶ Head is magnetized.

¶ Tape is damaged or of poor quality.

¶ Tape is bad (stretched or deformed,

etc.).

¶ Cassette shell is warped.

¶ Recording level is too high.

¶ Faulty connection between deck and

stereo amplifier/receiver.

¶ Head is dirty.

¶ Head is magnetized.

¶ Worn out or poor quality tape.

¶ Connection(s) improperly made.

¶ Affected by external electrical noise.

¶ Dirty capstan, pinch roller, etc., or poor

tape.

¶ Tape is wound unevenly.

¶ Slack tape, or tape spillage wound

around capstan.

¶ REC LEVEL control is set too low.

¶ Protective tabs are broken off.

¶ Recorded section is too short.

¶ Recorded section has low-level portions.

¶ Conversation, etc. has been recorded.

¶ Dolby NR-recorded tape is played back in

OFF position.

Cure

¶ Reinsert plug properly.

¶ Rewind tape or flip it over.

¶ Do not play damaged tapes.

¶ Load a cassette tape.

¶ Change tape or cover protective hole

with adhesive tape.

¶ Clean head.

¶ Demagnetize head using head

demagnetizer.

¶ Change to a different tape.

¶ Replace with a fresh tape.

¶ A warped cassette shell cannot be

fixed. Replace with another tape and

test.

¶ Check input level with peak level meter

and use lower rec level when recording.

¶ Check and secure connections.

¶ Clean head.

¶ Demagnetize head with head

demagnetizer.

¶ Change to better tape.

¶ Check input and output connections

and reinsert properly.

¶ Move away from electrical appliances

(TV, fluorescent light, electric blanket,

etc.).

¶ Clean capstan or pinch roller, or

change to better tape.

¶ Rewind tape.

¶ Remove the wound tape carefully. To

avoid this, insert pencil in hole in

cassette shell and turn to take up slack

in advance.

¶ Adjust REC LEVEL control.

¶ Change tape or cover protective hole with

adhesive tape.

¶ Blank sections must be at least 4 seconds

long.

¶ Playback in appropriate Dolby NR

position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha KX10 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info