557202
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
ASSEMBLY FIGURE
ASSEMBLY PROCEDURES
Before beginning assembly, check the parts list and make sure all the parts are included.
ASSEMBLY PROCEDURES
(You will need a screwdriver for assembly.)
1. Attaching the base and support.
Pass the support through the hole from the bottom of the base,
and fasten the + self-binding tapping screws
1.
Fix the support so that the holes for the screws comes to the
rear side.
Do not overtighten the + self-binding tapping screws 1.
Doing so may damage the screws or assembly.
2. Attaching the pole and support.
Insert the pole to the support, and fasten the hexagon socket
set screws 2 into the three hole on the support using the
included wrench 5.
The line on the pole shows the limit of the stand height. Do
not use the stand pulling out the pole above from this line.
The hexagon socket set screw 2 of the lower side becomes
ineffective and the fixation becomes unstable.
3. Attaching the pads.
Put the pads 4 to the four corners on the bottom of the base to
prevent the stand from moving rickety.
4.
Attaching the gaskets.
Put the gaskets 6 to the both side of the plate.
5.
Wiring the speaker cables.
Insert the speaker cables to the hole on the plate, and aligned
them to the grooved part on the bottom of the base.
6. Attaching the speakers.
Line up the holes on the bottom of the speaker and the center
hole on the plate, and fasten the + binding screws 3.
In order to ensure that the speakers do not fall, always hold
the speakers while attaching the speakers.
PARTS LIST
NAME PARTS NOS.
QUANTITY
1 + self-binding tapping screws EP040090 12
(4 x 12)
2 Hexagon socket set screws VV249400 7
3 + self-binding screws (4 x 8) EG340360 4
4 Pads VV249200 8
5 Wrench (hexagonal) VV249500 1
6 Gaskets VV249300 4
Speaker
Speaker
cable
Pole
Limit of the stand
height
Plate
Support
Base
6
3
6
3
2
2
4
1
1
4
5
SPS-10MM(E)k 02.2.28 3:04 PM ページ 2
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha SPS-10MM wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info