557204
3
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
English
E-3
6
Pull out the speaker cable in the length of 15 to 16
cm from the speaker mounting bracket. Then attach
the speaker mounting bracket to the pole so that
the speaker cable fits to the cut in the pole. This
will lock the speaker cable. After that, fasten the
screw.
7
Insert the pole to the support, and adjust the height
of the stand. After adjusting the height, fasten the
hexagon socket set screws into the two holes on
the support using the longer handle of the included
wrench, and attach the rubber cap to the support.
* The line on the pole shows the limit of the stand
height. Do not let the line of the stand height limit go
beyond the upper end of the support. Otherwise, the
hexagon socket set screw of the lower side becomes
ineffective and the fixation becomes unstable.
8
Adjust the speaker direction. Then put the wrench
into the hole of the speaker monting braket, and
tighten the bracket to the speaker by moving the
wrench counterclockwise.
9
Connect the speaker cable to the speaker’s
terminals correctly.
* Refer to the instruction manual of the speakers for
connecting the speaker cables.
10
Align the speaker cable to the grooved part of
the bottom of the base, and fix the cable on the
base by putting the protection seal on it.
The setup has completed.
In the same way, set up the other stand.
Make sure to note the following when stretching or
shortening the pole after the setup.
Make sure to remove the cable protection seal before
stretching or shortening the pole.
When stretching the pole, pull out the pole carefully with
the speaker stand laying along.
When shortening the pole, retract the pole carefully
while pulling out the speaker cable slowly by hand from
the base side with the speaker stand laying along.
Wrench
(hexagonal)
15–16 cm
* Rubber cap
Hexagon
socket set
screw
Stand height
limit
Support
Cable
protection
seal
Cut
* The inside of the rubber cap has a space for
storing the wrench after the setup.
Screw
SPS-80 ENG(02.6.17)b 02.6.19, 11:57 AM3
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yamaha SPS-80 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info