Bedienungsanleitung Yardforce YF3100ES-R (Seite 21 von 24) (Englisch)

734894

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

STORAGE

WINTER STORAGE

CAUTION

You must protect your pressure washer from

freezing temperatures.

• Failure to do so will permanently damage your pump and

render your unit inoperable.

• Freeze damage is not covered under warranty.

To protect the pressure washer from freezing

temperatures:

1. Follow steps 1-6 in the previous section “After Each

USE”.

2. Use pump saver, to treat pump. This prevents freeze

damage and lubricates pistons and seals.

3. If pump saver is not available, connect a 3-foot section

of garden hose to the water inlet adapter. Pour RV-

antifreeze (antifreeze without alcohol) into the hose. Pull

the recoil handle twice. Disconnect 3-foot hose.

4. Store the pressure washer in a clean, dry area.

LONG TERM STORAGE

If you do not plan to use the pressure washer for more than

30 days, you must prepare the engine and pump for long

term storage.

It is important to prevent gum deposits from forming in

essential fuel system parts such as the carburetor, fuel

filter, fuel hose or tank during storage. Also, experience

indicates that alcohol-blended fuels (called gasohol, ethanol

or methanol) can attract moisture, which leads to separation

and formation of acids during storage. Acidic gas can

damage the fuel system of an engine while in storage.

Protect Fuel System

Fuel Additive:

Fuel can become stale when stored over 30 days. Stale fuel

causes acid and gum deposits to form in the fuei system

or on essential carburetor parts. To keep fuel fresh, we

recommend use the fuel additive supplied by a qualified

Yardforce service dealer.

There is no need to drain gasoline from the engine if a fuel

stabilizer is added according to instructions. Run the engine

for 2 minutes to circulate the stabilizer throughout the fuel

system before storage.

If gasoline in the engine has not been treated with a fuel

stabilizer, it must be drained into an approved container.

Run the engine until it stops from lack of fuel.

The use of a fuel stabilizer in the storage container is

recommended to maintain freshness.

Change Oil

While engine is still warm, drain oil from crankcase. Refill

with recommended grade. See "Changing Oil" section.

Oil Cylinder Bore

1. Remove spark plug. Squirt about 1 tablespoon of clean

engine oil into the cylinder. Cover spark plug hole with

rag. Pull recoil handle slowly to distribute oil. Avoid spray

from spark plug hole.

2. Install spark plug. Do Not connect spark plug wire.

Protect Pump

To protect the pump from damage caused by mineral

deposits or freezing, use Pump Saver, to treat pump. This

prevents freeze damage and lubricates pistons and seals.

NOTE

Pump Saver is available as an optional accessory. It

is not included with the pressure washer.

Contact your local Yardforce service center to purchase

Pump Saver.

CAUTION

You must protect your unit from freezing

temperatures.

• Failure to do so will permanently damage your pump and

render your unit inoperable.

• Freeze damage is not covered under warranty.

To use the Pump Saver:

CAUTION

Read and follow all cautions and warnings on

the pump saver can label. Always wear eye protection when

using pump saver.

1. Remove the hose connector from the pump outlet.

2. Attach hose on pump saver can to pump inlet.

3. Push in can top to dispense pump saver.

4. When pump saver uid begins to exit pump outlet, the

pump is protected.

5. Remove pump saver from pump inlet.

Other Storage Tips

1. DO NOT store fuel from one season to another unless it

has been treated as described in Protect Fuel System.

2. Replace fuel container if it starts to rust. Rust and/ or dirt

in fuel can cause problems if it's used with this pressure

washer.

3. Cover unit with a suitable protective cover that does not

retain moisture.

WARNING Storage covers could cause a re resulting

in death or serious injury.

• DO NOT place a storage cover over a hot pressure

washer.

• Let equipment cool for a sucient time before placing the

cover on the equipment.

4. Store pressure washer in a clean and dry area.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yardforce YF3100ES-R Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info