35970
35
Zoom out
Zoom in
Vorherige Seite
1/84
Nächste Seite
FT-60R OPERATING MANUAL 33
MEMORY MODE
MEMORY BANK OPERATION
The large number of memories available in the FT-60R could be difficult to utilize without
some means of organizing them. Fortunately, the FT-60R includes provision for dividing
the memories into as many as ten Memory Groups, so you can categorize the memories in
a manner convenient to you. You may enter and exit the “Memory Group” mode by a
single press of the
[
BAND
(
BAND DN
)]
key, as we shall see below.
Assigning Memories to a Memory Bank
1. Recall the memory channel to be assigned to a Memory Bank.
2. Press and hold in the
[
BAND
(
BAND DN
)]
key for one second,
then rotate the DIAL knob to select the Memory Bank number
you want as the Memory Bank for this channel (“BANK 1” ~
BANK10”).
3. Press and hold in the
[
F/W
]
key for one second to copy the memory
channel data into the Memory Bank.
1) You may assign one
memory channel into several
Memory Banks.
2) The PMS memory channels (L1/U1
through L50/U50) may not be assigned
to a Memory Bank.
Memory Bank Recall
1. Press the
[
V/M
(
PRI
)]
key, if needed, to enter the Memory mode.
2. Press and hold in the
[
BAND
(
BAND DN
)]
key, then rotate the
DIAL knob to select the desired Memory Bank (“BANK 1
through “BANK10”).
3. Press the
[
V/M
(
PRI
)]
key momentarily; now, as you rotate the
DIAL knob to select memories, you will observe that you can
only select memory channels in the current memory bank. The
” indication will appear at the left side of the frequency
display while operating within a Memory Bank.
4. To change to another Memory Bank, press and hold in the
[
BAND
(
BAND DN
)]
key,
rotate the DIAL knob to select the new Memory Bank, then press the
[
V/M
(
PRI
)]
key
momentarily.
5. To exit from Memory Bank operation, select “NOBANK” in step 4 above. You are
now in the “standard” Memory Recall mode, without utilization
of the Memory Banks. The memories stored in the various Banks
will remain in those banks, however; you do not need to store
them again.
Memory Channel
CH 000 145.000 MHz
CH 001 145.500 MHz
CH 002 435.000 MHz
CH 003 435.500 MHz
CH 004 145.800 MHz
CH 005 436.000 MHz
CH 006 128.800 MHz
CH 997 145.620 MHz
CH 998 436.780 MHz
CH 999 128.600 MHz
Memory Bank “5
Air Band Channels
Memory Bank “4
Club Channels
Memory Bank “3
All Amateur Band Channels
Memory Bank “1
144 MHz Amateur Band Channels
Memory Bank “2
430 MHz Amateur Band Channels
35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Yaesu FT-60R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info