30
The furniture door plinth
The door on this appliance is designed for the overlay
of a door plinth having the following dimensions:
Width: 596 mm
Height: 50 mm (min) - 120 mm (max)
Thickness: 20 mm max
The panel height should be no more than indicated,
otherwise complete opening of the door will no longer
be possible as the panel hits against the dishwasher
plinth.
Mounting the infill panel
1. Drill the panel with a Ø 2 x 12 bit according to the
dimensions indicated in the figure.
2. Fix the panel to the cross bar provided with 2
screws 3.5 x 16.
3. Fix the cross bar to the dishwasher door with 2
screws 3.5 x 16 after having inserted the two hooks
of the cross bar on the lower section of the door.
Fixing to the adjacent units
To prevent the dishwasher tilting, it must be secured to
either the worktop or adjacent kitchen cabinet/wall
using the brackets supplied.
Insert the two fixing brackets into the slots provided in
the top front part of the dishwasher as shown in the
figure.
Secure the brackets to the adjacent units with the
3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the
underside of the worktop using the brackets
provided.
Failure to do this could cause damage or
injury.
Attention!
The sides of the dishwasher must never be
drilled to prevent damage to hydraulic
components.
INS66en
