729835
3
Zoom out
Zoom in
Vorherige Seite
1/7
Nächste Seite
3
The installation of the ZENEC system should be carried out by an authorized installer. Specic
knowledge and tools are required to do the installation. Incorrect installation can cause damage to the
vehicle and the ZENEC system.
Correct functioning can only be guaranteed when you use the ZENEC original accessories included
in the kit or those optionally available. The ZENEC system and the original accessories must under no
circumstances be modied or altered in any way. Inappropriate actions can cause damage to the
vehicle and the ZENEC system.
Torx screwdriver T25
Release tool made of plastic
Insulating tape
The target vehicle must factory congured with one of the OE radio or navigation systems, listed
on the previous page. The ZENEC system is not compatible with vehicles, which are equipped with a
hybrid or electro drive ex factory.
This device installation manual applies to vehicle platforms appearing in the compatibility list on the
previous page, and in a condition as offered by the respective vehicle manufacturer. Other differing
congurations and installations may result in complications and malfunctions.
The ZENEC system is equipped with an integrated DAB+ receiver. To make use of this you will need
a suitable DAB antenna (not included in kit) that must be connected to the ZENEC system.
If the target vehicle is already equipped with an original DAB antenna, it is still possible to use it in
combination with the ZENEC system. Please use the DAB antenna connector (No. 6), which is part of
the kit, for connection.
The Z-E2050 comes with an adaptor interface, which ts to the double FM antenna plug from the
vehicle. If this solution is not sufcient, e.g. the FM radio reception is deemed to be poor, the
ZE-NC-ANT3 phantom power adaptor which is separately available, may help to improve FM signal
level.
Software updates to the ZENEC system are installed with a USB memory device. Therefore when
tting the system make sure that the USB connection of the ZENEC system will still be accessible
later (installation of USB extension cable or USB hub).
If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom you purchased it.
Additional questions about the compatibility could be answered by using the ZENEC online
congurator:
www.zenec.com/congurator
TOOLS REQUIRED
No. Article Qty
1 ZENEC system 1
2 GPS antenna 1
3 Double-sided adhesive pad 1
4 Main connection cable Quadlock II 1
THE KIT INCLUDES
5
CAN bus interface 1
6
DAB antenna adapter (Fakra – SMB) 1
7
USB extension cable
1
8
24-pin connection cable (4.2, Cam, Mic)
1
9
FM antenna adapter (Single to twin Fakra)
1
ZENEC ZE-NC-ANT3 (antenna interface)
DAB antenna with SMB plug
(e.g. Z-EACC-DAB1 or Z-EACC-DAB2)
External microphone (N-ZENC-MIC)
ADDITIONAL MOUNTING ACCESSORIES
CAUTION
NOTE
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Zenec Z-E2050 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Zenec Z-E2050

Zenec Z-E2050 Installationsanweisung - Deutsch - 7 seiten

Zenec Z-E2050 Bedienungsanleitung - Deutsch - 77 seiten

Zenec Z-E2050 Bedienungsanleitung - Englisch - 77 seiten

Zenec Z-E2050 Bedienungsanleitung - Holländisch - 77 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info