713909
21
Zoom out
Zoom in
Vorherige Seite
1/112
Nächste Seite
ENGLISH
21
YOUNGSTER 3
Tyres and Mounting
Always make sure you that you maintain the correct tire
pressure, as this can have an effect on wheelchair performance.
If the tire pressure is too low, rolling resistance will increase,
requiring more effort to move the chair forward; Low tire
pressure also has a negative impact on maneuverability. If the
tyre pressure is too high, the tyre could burst. The correct
pressure for a given tyre is printed on the surface of the tyre
itself. Tyres can be mounted the same way as an ordinary
bicycle tyre. Before installing a new inner tube, you should
always make sure that the base of the rim and the interior of the
tyre are free of foreign objects. Check the pressure after
mounting or repairing a tyre. It is critical to your safety and to
the wheelchair’s performance that regulation air pressure be
maintained and that tyres are in good condition.
5.0 Tyres and Mounting
Please open on each side of the frame the screws (1) and
separate the frame from the cross brace. Then take the
composite sleeves (2) out of their position in the cross brace
ends, turn them 180° and put them back into the cross brace
ends in the reversed position. Afterwards open the central cross
brace bolt (3) and remove the bolt. Then remove and reverse
the composite sleeves (4) also 180° and reposition them at the
cross brace. Now install the central bolt into the cross brace
again and close the screw with 7 NM. Finally bring the frames
and the cross brace together and close the screws (1) with 7
Nm again.
In order to adjust the seat upholstery open the screws (1),
remove the seat rail end plugs and pull the upholstery off the
seat rails. Then adjust the width of the upholstery with the
Velcro below the seat. Finally install the upholstery and the end
plugs in the seat rails and tighten the screws (See Fig. 4.27)
The back upholstery is width adjustable with Velcro straps –
both the straps as well as the cover therefore have Velcro parts
attached.
Finally the footrest offer a width adjustment over clamps (see
chapter footrests page.12)
Seat width growth (Fig. 4.32 / 4.33)
In order to adjust the seat depth, please open both screws (1)
on each side of the cross brace / seat rails. Then move the seat
rail and seat upholstery to the dedicated position, ensure that
both sides are aligned and then tighten the screws (1) with 5
Nm. again. Finally it might be needed to re-position the saddles
(2) in one position.
Seat depth growth (Fig. 4.34)
Fig. 4.32
1
2
Fig. 4.33
3
4
Fig. 4.34
1
2
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Zippie Youngster 3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info