22
Adding a new device
If you have already paired 2 Powerline adapters and you want to add more, you can
also connect them to your network, by following the next steps:
1. Plug the new Powerline adapter into a power socket. Wait 1 minute before
applying step 2 (booting time).
2. On any of the already pre-paired Powerline adapter press the SECURITY or
Config button for more than 2 seconds until the Powerline LED starts
blinking.
3. Press the SECURITY or Config button (more than 2 seconds) of the new
Powerline adapter you want to add to your network. The Powerline LED will
also start blinking.
4. Wait till the Powerline LED of both Powerline adapters stop blinking. If the
coverage between both units is good the LED of both will show a fixed
GREEN color. On the contrary, if the signal quality between both Powerline
adapters is not optimal the LED will show the color ORANGE (medium
coverage) or RED (bad coverage).
5. If needed, connect your network device (e.g. computer, IP camera, video
recorder, etc.) to the new paired Powerline adapter via an Ethernet cable.
