24
Connect multiple adapters
If you have problems connecting multiple adapters, please try as follows:
Reset all adapters to factory settings.
Plug all adapters together into a multiple socket.
Press the pairing button (SECURITY or CONFIG for more than 2 sec.) immediately
after each other.
After a short wait two adapters will connect.
It can take up to 1 to 2 minutes for the third adapter to connect.
If the Powerline LED on the third adapter stops flashing and goes off without any
connection, continue with the following steps:
Press the pairing button again at the first adapter of the already paired ones, after
that press the paring button at the third adapter again.
Please note, during the pairing process, the Powerline LED on the ITAC10310
adapter flashes at least 1 minute longer than on the ITAC10300.
If this does not succeed again, the third adapter may be defective.
Please check if a simple pairing with only two adapters is possible to identify the
defective adapter.
WARNING
• Disconnect the Powerline adapter from the power source before servicing
• For indoor user only
• Do NOT open the casing
• Do NOT use near water
• Do NOT insert sharp objects into the adapter’s socket
• Socket maximum output is 15A (ITAC10300)
