1-13 Use softened water to make coffee or tea. Well / municipal water should be softened to
prevent scaling in the boiler, which will shorten the serviceable life of your machine. If a
hard water source is used, the lter should be replaced every two weeks -- although
long-life lters may remain serviceable up to eight weeks. Actual lter replacement
scheduling will vary based on volume and quality of water used.
1-14 The machine rells water automatically (see Section 4-2 for initializing). An error code will
appear if water ow into the machine exceeds two minutes (see Troubleshooting Section
in this manual), and power will be cut off automatically to protect the system. To resume
normal functions, restart the system after three or more seconds.
1-15 The heating element will not operate when water in the machine is less than the minimum
required level. When starting the machine without any water in the tank, heating will be
delayed for about 60 seconds.
1-16 Please ensure the water inside the piping will not be frozen while using the machine. The
water temperature must maintain over the freezing point even during the power off
period. The warranty does not cover any damages on piping and boiler cost by frozen
water.
1-17 When turning off the machine for long-term, please be sure to evacuate the water inside
the piping completely. For this may freeze the water and lead to damaging the machine.
To ensure the safety of your machine, please notify your service representative regarding
any needs on operations in frigid zone or prepare to shut down the machine for long-term
for complete water evacuation.
2. Operating Precautions
Do not use the machine and turn off the power when water intake has ceased.
When operating the machine for the rst time or replacing the lter, remove the water inlet
tube and allow it to drain for about one minute in order to discharge impurities from the
water.
Please check and conrm normal water supply before turning on power.
Please check and conrm water level registers within the green zone. Operating the
machine outside the green zone may cause the electric heating element to overheat and
burn out.
After installing the machine, please check to make sure that, during water intake, the
steam pressure gauge indicator is within the green zone (1~1.4bar) and the water
pressure gauge indicator is also within the green zone (8~10bar). Please adjust the
system to the water supply pressure conditions in your area.
The water and steam taps are used to make coffee or tea. The nozzle at the hot water
outlet and the steam outlet are very hot -- please do not touch.
4
