665656
3
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
9
V 12/15
HOW TO USE THE APPLIANCE
The appliance is supplied without casters. Mount the casters before using it.
Place the unit on a flat and stable surface then connect the power cord to a suitable socket (220–240 V): start the
appliance by pressing the ON/OFF button. Pressing the ON/OFF button again causes the unit to emit a buzzer before
switching off.
This product can be used both as a fan – with 3 modes (Normal, Natural and Sleeping) and 3 fan speeds (low,
medium, high) available – and as a cooler/humidifier: in this case, the rear tank must be filled with demineralised
water without exceeding the maximum limit indicated on the tank itself.
To enhance the product's cooling power, add synthetic ice (not supplied) to the water in the tank.
Do not use this cooler in very humid and dusty areas, or with temperatures exceeding 40°C.
When the water in the tank falls below the minimum level marked on the tank, the appliance emits a continuous sound to
signal the low water level before it stops the cooling mode. The unit deactivates automatically when the tank is removed.
The fan takes in air from the room and passes it through the dust filter and the evaporative panel, which is kept constantly
humidified thanks to a system that draws water from the tank and sprays it onto the panel. The incoming hot air causes
part of the water contained in the panel to evaporate; the air thus released back into the room is cooler, which makes it
feel as though the temperature has dropped.
Plug in the appliance correctly; the ON/OFF indicator light will switch on.
The Cooler can be controlled from the control panel or from a remote control.
The remote control can function up to 5 m away, at an angle of roughly 20°.
DISPLAY AND CONTROL PANEL
REMOTE CONTROL
ON/OFF BUTTON: Press the ON/OFF button. The ventilation speed is pre-set to medium and the mode to NORMAL.
Press the ON/OFF button once to switch the appliance off.
SPEED BUTTON: Press the SPEED button to select the desired ventilation speed (Low / Medium / High). The ventilation
speed changes and the indicator light turns to a different colour.
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Argo Bear wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Argo Bear

Argo Bear Bedienungsanleitung - Deutsch - 6 seiten

Argo Bear Bedienungsanleitung - Französisch - 6 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info