LIMIT (orange LED)
It indicates the Overload Limiter circuit is on.
Caution:
When this led is on (although sporadically), it means the applied load is a hard one. The activation
of Overload Limiter circuit (output power limiter) will anyway allow the amplifier to function
without distortions. In case Overload Limiter gets on too frequently (at every power peak), you will
need to check if there are any failures or a too hard load (that’s to say impedance is about 50%
lower than the minimum recommended one). The amplifier can go on functioning in these
conditions but power will inevitably decrease.
1
ON (green LED)
It indicates the
amplifier is on.
2
CENTER (Level)
It adjusts the amplifier Center channel input sensitivity and sets its output level.
3
1
2
3
4
5
10
9
8
6
7
11
13
ACCESSORIES
LRx 6.SR can accept one of the optional kits that allow the subwoofer volume remote control. VCR01K
and VCRAK are analogue and special for sub;VCRDK is digital and can be used for master volume control
or for level control of any ways in a multichannel system.
These kits are available as accessories and consist of three elements:
1) Volume adjuster (VCR01/VCRA/VCRD);
2) VCA/VCA1D module to put inside the amplifiers;
3) Wire to connect VCR01/VCRA/VCRD adjusters to the proper sockets in the amplifier rear panel and to
the car lights switch, in order to light it up.
Install VCR01/VCRA/VCRD adjusters in a place you can easily and comfortably reach, according to the
following connection diagram.
VCR01K,VCRAK and VCRDK
