Bedienungsanleitung BEKO WMP 511S (Seite 3 von 20) (Englisch)

556971

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

3/EN

Washing Machine / User’s Manual

2 Installation

RefertothenearestAuthorisedServiceAgentforinstallation

oftheproduct.Tomaketheproductreadyforuse,review

the information in the user manual and make sure that the

electricity,tapwatersupplyandwaterdrainagesystemsare

appropriatebeforecallingtheAuthorizedServiceAgent.Ifthey

arenot,callaqualifiedtechnicianandplumbertohaveany

necessary arrangements carried out.

INFORMATIONS

Preparationofthelocationandelectrical,tapwaterandwaste

water installations at the place of installation is under customer’s

responsibility.

Make sure that the water inlet and discharge hoses as well as the

powercablearenotfolded,pinchedorcrushedwhilepushingthe

product into its place after installation or cleaning procedures.

B WARNING

Installationandelectricalconnectionsoftheproductmustbe

carriedoutbytheAuthorizedServiceAgent.Manufacturershallnot

beheldliablefordamagesthatmayarisefromprocedurescarried

outbyunauthorizedpersons.

A WARNING

Priortoinstallation,visuallycheckiftheproducthasanydefectson

it.Ifso,donothaveitinstalled.Damagedproductscauserisksfor

your safety.

2.1 Appropriate installation location

• Placethemachineonarigidfloor.Donotplaceitonalong

pile rug or similar surfaces.

• Totalweightofthewashingmachineandthedryer-with

full load- when they are placed on top of each other

reachestoapprox.180kilograms.Placetheproductona

solid and flat floor that has sufficient load carrying capacity!

• Donotplacetheproductonthepowercable.

• Donotinstalltheproductatplaceswheretemperaturemay

fallbelow0ºC.

• Placetheproductatleast1cmawayfromtheedgesof

other furniture.

2.2 Removing packaging reinforcement

Tiltthemachinebackwardstoremovethepackaging

reinforcement.Removethepackagingreinforcementby

pullingtheribbon.

2.3 Removing the transportation locks

A WARNING

Donotremovethetransportationlocksbeforetakingoutthe

packaging reinforcement.

Removethetransportationsafetyboltsbeforeoperatingthe

washingmachine!Otherwise,theproductwillbedamaged.

Loosenalltheboltswithasuitablespanneruntiltheyrotate

freely(C).Removetransportationsafetyboltsbyturningthem

gently.AttachtheplasticcoverssuppliedintheUserManual

bagintotheholesontherearpanel.(P)

INFORMATIONS

Keepthetransportationsafetyboltsinasafeplacetoreusewhen

thewashingmachineneedstobemovedagaininthefuture.

Nevermovetheproductwithoutthetransportationsafetybolts

properly fixed in place!

2.4 Connecting water supply

INFORMATIONS

Thewatersupplypressurerequiredtoruntheproductisbetween

1to10bars(0.1–1MPa).Itisnecessarytohave10–80liters

of water flowing from the fully open tap in one minute to have your

machinerunsmoothly.Attachapressurereducingvalveifwater

pressure is higher.

Ifyouaregoingtousethedoublewater-inletproductasasingle

(cold)water-inletunit,youmustinstallthesuppliedstopperto

thehotwatervalvebeforeoperatingtheproduct.(Appliesforthe

productssuppliedwithablindstoppergroup.)

Ifyouwanttousebothwaterinletsoftheproduct,connectthe

hot water hose after removing the stopper and gasket group from

thehotwatervalve.(Appliesfortheproductssuppliedwithablind

stopper group.)

A WARNING

Modelswithasinglewaterinletshouldnotbeconnectedtothe

hotwatertap.Insuchacasethelaundrywillgetdamagedorthe

product will switch to protection mode and will not operate.

Donotuseoldorusedwaterinlethosesonthenewproduct.Itmay

cause stains on your laundry.

Connectthespecialhosessuppliedwiththeproducttothe

waterinletsontheproduct.Redhose(left)(max.90ºC)isfor

hotwaterinlet,bluehose(right)(max.25ºC)isforcoldwater

inlet.

1.6 Compliance with the WEEE Directive

and Disposing of the Waste Product:

ThisproductcomplieswithEUWEEEDirective

(2012/19/EU).Thisproductbearsaclassification

symbolforwasteelectricalandelectronic

equipment(WEEE).

Thisproducthasbeenmanufacturedwithhigh

qualitypartsandmaterialswhichcanbereused

andaresuitableforrecycling.Donotdisposeof

the waste product with normal domestic and other wastes at

the end of its service life. Take it to the collection center for

therecyclingofelectricalandelectronicequipment.Please

consultyourlocalauthoritiestolearnaboutthesecollection

centers.

BEKO WMP 511S Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info