Bedienungsanleitung BEKO WMP 511S (Seite 4 von 20) (Englisch)

556971

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

4/EN

Washing Machine / User’s Manual

A WARNING

Ensurethatthecoldandhotwaterconnectionsaremadecorrectly

wheninstallingtheproduct.Otherwise,yourlaundrywillcomeout

hot at the end of the washing process and wear out.

Tightenallhosenutsbyhand.Neveruseawrenchwhen

tightening the nuts. Open the taps completely after making the

hose connection to check for water leaks at the connection

points.Ifanyleaksoccur,turnoffthetapandremovethenut.

Retightenthenutcarefullyaftercheckingtheseal.Toprevent

waterleakagesanddamagescausedbythem,keepthetaps

closed when the machine is not in use.

2.5 Connecting to the drain

• Theendofthedrainhosemustbedirectlyconnectedto

thewastewaterdrainortothewashbasin.

A WARNING

Donotremovethetransportationlocksbeforetakingoutthe

packaging reinforcement.

• Thehoseshouldbeattachedtoaheightofatleast40cm,

and 100 cm at most.

• Incasethehoseiselevatedafterlayingitonthefloorlevel

orclosetotheground(lessthan40cmabovetheground),

waterdischargebecomesmoredifficultandthelaundry

maycomeoutexcessivelywet.Therefore,followthe

heightsdescribedinthefigure.

• Topreventflowingofdirtywaterbackintothemachineand

toallowforeasydischarge,donotimmersethehoseend

into the dirty water or do not drive it in the drain more than

15cm.Ifitistoolong,cutitshort.

• Theendofthehoseshouldnotbebent,itshouldnotbe

steppedonandthehosemustnotbepinchedbetweenthe

drain and the machine.

• Ifthelengthofthehoseistooshort,useitbyadding

an original extension hose. Length of the hose may not

belongerthan3.2m.Toavoidwaterleakfailures,the

connectionbetweentheextensionhoseandthedrain

hoseoftheproductmustbefittedwellwithanappropriate

clamp as not to come off and leak.

2.6 Adjusting the feet

A WARNING

Inordertoensurethattheproductoperatesmoresilentlyand

vibration-free,itmuststandlevelandbalancedonitsfeet.Balance

themachinebyadjustingthefeet.Otherwise,theproductmay

movefromitsplaceandcausecrushingandvibrationproblems.

Loosenthelocknutsonthefeetbyhand.Adjustthefeetuntil

theproductstandslevelandbalanced.Tightenalllocknuts

againbyhand.

A WARNING

Donotuseanytoolstoloosenthelocknuts.Otherwise,theywill

get damaged.

2.7 Electrical connection

Connecttheproducttoagroundedoutletprotectedbya13

Afuse.Ourcompanyshallnotbeliableforanydamages

that will arise when the product is used without grounding in

accordance with the local regulations.

• Connectionmustcomplywithnationalregulations.

• Powercableplugmustbewithineasyreachafter

installation.

• Ifthecurrentvalueofthefuseorbreakerinthehouseis

lessthan13Amps,haveaqualifiedelectricianinstalla13

Ampfuse.

• Thevoltagespecifiedinthe“Technicalspecifications”

sectionmustbeequaltoyourmainsvoltage.

• Donotmakeconnectionsviaextensioncablesormulti-

plugs.

WARNING: Damagedpowercablesmustbe

replacedbytheAuthorizedServiceAgents.

Electrical requirements

Beforeyouinserttheplugintothewallsocketmakesure

thatthevoltageandthefrequencyshownintheratinglabel

corresponds to your electricity supply.

Werecommendthatthisappliancebeconnectedtothemains

supplyviaasuitableswitchedandfusedsocketinareadily

accessibleposition.

Shouldthemainsleadoftheappliancebecomedamagedor

needreplacingatanytime,itmustbereplacedbyaspecial

purposemademainsleadwhichcanonlybeobtainedfroma

AuthorisedServiceAgent.

WARNING: Thisappliancemustbeearthed

Ifthefittedmouldedplugisnotsuitableforyoursocket,then

theplugshouldbecutoffandanappropriateplugfitted.

Destroytheoldplug,whichiscutoffasaplugwithabared

cordcouldcauseashockhazardifinsertedintoasocket

elsewhere in the house.

Themouldedplugonthisapplianceincorporatesa13A

fuse.ShouldthefuseneedtobereplacedanASTAapproved

BS1362fuseofthesameratingmustbeused.Donotforget

torefitthefusecover.Intheeventoflosingthefusecover,

theplugmustnotbeuseduntilareplacementfusecoverhas

beenfitted.Colourofthereplacementfusecovermustbethe

samecolourasthatvisibleonthepinfaceoftheplug.Fuse

coversareavailablefromanygoodelectricalstore.

BEKO WMP 511S Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info