Bedienungsanleitung Bestway 56283 My First Frame (Seite 2 von 3) (Englisch)

686195

Zoom out

Zoom in

Vorherige Seite

1/3

Nächste Seite

S-S-005849

Preparation

A single-handed installation of a small swimming pool usually takes only 10

minutes. Recommendations regarding placement of the pool:

• It is essential for the pool to be set up on solid, leveled ground. If the pool is

set up on uneven ground it can result in collapse and flooding, causing

serious personal injury and/or damage to personal property. Setting up on

uneven ground will void the warranty and service claims.

• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground

should be firm enough to withstand water pressure; mud, sand, soft / loose

soil or tar are not suitable.

1. Take the pool and accessories out of the carton with care. Spread the pool

out onto the selected site.

2. Close the water valve.

3. Insert all the Top Rails into the pole sleeve on the top of the pool. (Fig.1)

Please see the structure photo for detailed directions.

4. Insert both ends of Top Rails into the Connector. Then insert Bolt into the

top of the Connector. (Fig.2) Repeat this procedure for remaining parts.

(Fig.3)

Note: In each Connector, ensure both Top Rails are properly inserted.

5. Attach all Footings to the bottom of the Vertical Pool Legs. Then insert the

Vertical Pool Legs into the bottom of the Connectors. (Fig.4)

6. Test frame to ensure all connections are secure before filling with water.

(Fig.5)

7. Add 1’’ (2 cm) of water into the pool to cover floor. Once pool floor is slightly

covered, gently smooth out all wrinkles. Start at the center of the pool and

work your way clockwise to the outside.

8. Continue to fill the pool until it reaches the water fill line located on the

pool’s interior. Please kindly pay the upmost attention to not over fill the

pool for security reasons.

Dismantling

1. Open water valve on the bottom of the pool, water will drain automatically.

(Check local regulations for drainage by-laws). Then dismantle pool frame

to release water. Make sure you release most of the water within 20 minutes.

Note: Only adults should drain the pool!

2. Air dry the pool.

ATTENTION: Do not leave the drained pool outside.

Repair

If your pool is damaged, use the provided repair patch.

1. Clean area to be repaired.

2. Carefully peel patch.

3. Press patch over area to be repaired.

4. Wait 30 minutes before inflation.

Pool Maintenance

Warning: If you do not adhere to the maintenance guidelines covered here in,

your health might be at risk, especially that of your children.

• Change the pool water frequently (particularly in hot weather) or when

noticeably contaminated, unclean water is harmful for the users.

• Please contact your local retailer for chemicals to treat water in your pool.

Be sure to follow the chemical manufacturer’s instructions.

• Proper maintenance can maximize your pool’s lifespan.

• See packaging for water capacity.

Cleaning and Storage

1. After use, clean surfaces gently with a damp cloth.

Note: Never use solvents or other chemicals that may damage the product.

2. Remove all accessories and spare parts of the pool, clean and dry them.

3. Once pool is completely dry, sprinkle with talcum powder to prevent the

pool from sticking together and fold the pool carefully. If pool is not

completely dry, mould may develop, which will damage the pool liner.

4. Store liner and accessories in a cool, dry place out of children’s reach, with

a moderate temperature between 5°C / 41°F and 38°C / 100°F.

5. During rainy season, pool and accessories should be stored as instructed

above.

6. Improper draining of the pool might cause serious personal injury and/or

damage to personal property.

7. Check the product for damage at the beginning of each season and at

regular intervals when in use.

Ref#

Top Rail

Vertical Pool Leg

Connector

Bolt

Footing

Description Quantity

9. Where a wall of a dwelling serves aspart of the barrier, one of the

following should apply:

(a) All doors with direct access to the pool through that wall should be

equipped with an alarm which produces an audible warning when the

door and its screen, if present, are opened. The alarm should sound

continuously for a minimum of 30 seconds within 7 seconds after the

door is opened. Alarms should meet the requirements of UL2017

General-Purpose Signaling Devices and Systems, Section 77. The

alarm should have a minimum sound pressure rating of 85 dBA at 10

feet and the sound of the alarm should be distinctive from other

household sounds, such as smoke alarms, telephones, and door bells.

The alarm should automatically reset under all conditions. The alarm

should be equipped with manual means, such as touchpads or

switches, to temporarily deactivate the alarm for a single opening of the

door from either direction. Such deactivation should last for no more

than 15 seconds. The deactivation touchpads or switches should be

located at least 54 inches above the threshold of the door.

(b) The pool should be equipped with a power safety cover which

complies with ASTM F1346-91 listed below.

devices, are acceptable so long as the degree of protection afforded is

not less than the protection afforded by (a) or (b) described above.

10. Where an aboveground pool structure is used as a barrier or where the

barrier is mounted on top of the pool structure, and the means of access is

a ladder or steps, then (a) the ladder to the pool or steps should be

capable of being secured, locked or removed to prevent access, or (b) the

ladder or steps should be surrounded by a barrier which meets Section I,

Paragraphs 1 through 9. When the ladder or steps are secured, locked, or

removed,any opening created should not allow the passage of a 4-inch

diameter sphere.

Section II: Barrier Locations

Barriers should be located so as to prohibit permanent structures, equipment

or similar objects from being used to climb the barriers.

Parts:

Liner Underwater adhesive repair patch

A B

C D E

Drawings may not reflect actual product, not scaled to size.

Structure photo:

Fig. 1

Fig. 3Fig. 2

Fig. 5Fig. 4

• Ground must be cleared of all objects and debris including stones and twigs.

• Check with your local city council for by-laws relating to fencing, barriers,

lighting and safety requirements and

ensure you comply with all laws.

Installation

Assembly can be completed without

tools.

NOTE: It is important to assemble pool

in the order shown below. Adult

assembly required.

Bestway 56283 My First Frame Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Bestway 56283 My First Frame

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info